enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. IBM 3270 - Wikipedia

   en.wikipedia.org/wiki/IBM_3270

   The DPC female connector was a few millimeters longer and with a built-in switch that detected if a normal BNC connector were connected or a newer DPC connector was connected, thereby changing the physical layer from 93 ohm unbalanced coax, to 150 ohm balanced twisted-pair, thereby directly supporting the IBM Cabling system without the need for ...

3. JP1 remote - Wikipedia

   en.wikipedia.org/wiki/JP1_remote

   A JP1 Remote Control. A JP1 remote is a type of universal remote, usually with a six-pin interface connector labeled "JP1" in the battery compartment, manufactured by Universal Electronics Inc. The JP1 interface allows the remote to be reprogrammed, adding new code lists and functions. Home theater hobbyists use JP1 to avoid obsolescence.

4. C connector - Wikipedia

   en.wikipedia.org/wiki/C_connector

   The C connector is a type of RF connector used for terminating coaxial cable. The interface specifications for the C and many other connectors are referenced in MIL-STD-348. [1] The connector uses two-stud bayonet-type locks. The C connector was invented by Amphenol engineer Carl Concelman. It is weatherproof without being overly bulky.

5. EIA RF Connectors - Wikipedia

   en.wikipedia.org/wiki/EIA_RF_Connectors

   They are commonly referred to by the inner diameter of the outer conductor in fractional inches. Sizes covered under these two standards range from 3/8 to 6 1/8 inch outside diameter (OD) for 50 Ω and 3/8 to 3 1/8 inch OD for 75 Ω.

6. Musa connector - Wikipedia

   en.wikipedia.org/wiki/Musa_connector

   The Musa connector (for Multiple Unit Steerable Array/Antenna) is a type of coaxial ("coax") connector, originally developed for the manual switching of radio signals. It has a characteristic impedance of 75 Ω, [1] and was adopted for use in the emerging television broadcast industry.

7. HomePNA - Wikipedia

   en.wikipedia.org/wiki/HomePNA

   HomePNA 3.1 was developed by Coppergate Communications [2] and was approved by the ITU as Recommendation G.9954 in January 2007. HomePNA 3.1 added Ethernet over coax . HomePNA 3.1 uses frequencies above those used for digital subscriber line and analog voice calls over phone wires and below those used for broadcast and direct-broadcast ...

8. SMA connector - Wikipedia

   en.wikipedia.org/wiki/SMA_connector

   A 5 ⁄ 16 inch torque wrench is required for this, set to 3–5 in·lbf (0.3 to 0.6 N·m) for brass, and 7–10 in·lbf (0.8 to 1.1 N·m) for stainless steel connectors. Flats are sometimes also provided on the cable side of the connector assembly so that a second wrench can be used to prevent it from rotating and damaging the joint to the cable.

9. SMB connector - Wikipedia

   en.wikipedia.org/wiki/SMB_connector

   SMB connectors are smaller than SMA connectors. They feature a snap-on coupling and are available in either 50 Ω or 75 Ω impedance. They offer excellent electrical performance from DC to 4 GHz. An SMB jack has a male center pin, while an SMB plug has a female basket. [1] [2] Connectors are available for two SMB cable sizes: