Search results
Results from the WOW.Com Content Network
Cars and trucks using direct air cooling (without an intermediate liquid) were built over a long period from the very beginning and ending with a small and generally unrecognized technical change. Before World War II, water-cooled cars and trucks routinely overheated while climbing mountain roads, creating geysers of boiling cooling water. That ...
Once the coolant reaches the thermostat's activation temperature, it opens, allowing water to flow through the radiator to prevent the temperature from rising higher. Once at optimum temperature, the thermostat controls the flow of engine coolant to the radiator so that the engine continues to operate at optimum temperature.
However, if the coolant engages in nucleate boiling but does not form a film, this helps disrupt the coolant boundary layer and the gas bubbles formed rapidly collapse; this can triple the maximum heat flow. However, many modern engines with turbopumps use supercritical coolants, and these techniques can be seldom used.
The bearings have to be leak-tight. A hermetic seal, usually a liquid seal, is employed; a turbine oil at pressure higher than the hydrogen inside is typically used. A metal, e.g. brass, ring is pressed by springs onto the generator shaft, the oil is forced under pressure between the ring and the shaft; part of the oil flows into the hydrogen side of the generator, another part to the air side.
A coolant is a substance, typically liquid, that is used to reduce or regulate the temperature of a system. An ideal coolant has high thermal capacity, low viscosity, is low-cost, non-toxic, chemically inert and neither causes nor promotes corrosion of the cooling system. Some applications also require the coolant to be an electrical insulator.
Nikola said that the coolant leak issue does not affect the company’s hydrogen fuel-cell EVs currently in production. Those vehicles have a different battery pack design.
Over the past 25 years, hydrogen fuel cells (HFC) have been the butt of countless jokes in the automotive industry. Many critics see the technology as something long in the works that will never ...
The aim is to produce the hydrogen on-board at a rate matching the demand of the car engine. We want to use the boron to save transporting and storing the hydrogen. A vehicle powered by the device would take on water and boron instead of petrol, and generate boron trioxide. Elemental boron is difficult to prepare and does not occur naturally.