Ad
related to: osmolality 300 mosm kg water
Search results
Results from the WOW.Com Content Network
Whereas osmolality (with an "l") is defined as the number of osmoles (Osm) of solute per kilogram of solvent (osmol/kg or Osm/kg), osmolarity (with an "r") is defined as the number of osmoles of solute per liter (L) of solution (osmol/L or Osm/L). As such, larger numbers indicate a greater concentration of solutes in the plasma.
In simpler terms, osmolality is an expression of solute osmotic concentration per mass of solvent, whereas osmolarity is per volume of solution (thus the conversion by multiplying with the mass density of solvent in solution (kg solvent/litre solution). =
Normal serum osmolality ranges from 280 to 290 mOsm/kg and serum osmolality to cause water removal from brain without much side effects ranges from 300 to 320 mOsm/kg. Usually, 90 mL of space is created in the intracranial vault by 1.6% reduction in brain water content. [1] Osmotherapy has cerebral dehydrating effects. [2]
Urine osmolality in humans can range from approximately 50 to 1200 mOsm/kg, depending on whether the person has recently drunk a large quantity of water (the lower number) or has gone without water for a long time (the higher number). [2] Plasma osmolality with typical fluid intake often averages approximately 290 mOsm/kg H 2 O in humans. [2]
Oncotic pressure values are approximately 290 mOsm per kg of water, which slightly differs from the osmotic pressure of the blood that has values approximating 300 mOsm /L. [citation needed] These colloidal solutions are typically used to remedy low colloid concentration, such as in hypoalbuminemia, but is also suspected to assist in injuries ...
[2] 290 mOsm/kg is the presumed stool osmolality, and the measured concentration of sodium and potassium cations is doubled to account for the corresponding anions which must be present. [citation needed] A normal gap is between 50 and 100 mOsm/kg, [3] corresponding to the concentration of other solutes such as magnesium salts and sugars ...
The 300 mOsm/L fluid from the loop loses water to the higher concentration outside the loop and increases in tonicity until it reaches its maximum at the bottom of the loop. This area represents the highest concentration in the nephron, but the collecting duct can reach this same tonicity with maximum ADH [ clarification needed ] effect.
For liquid solutions, the osmotic coefficient is often used to calculate the salt activity coefficient from the solvent activity, or vice versa. For example, freezing point depression measurements, or measurements of deviations from ideality for other colligative properties, allows calculation of the salt activity coefficient through the osmotic coefficient.
Ad
related to: osmolality 300 mosm kg water