enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   The major minus pitch technique also works for inch-based threads, but you must first calculate the pitch by converting the fraction of threads-per-inch (TPI) into a decimal. For example, a screw with a pitch of 1/20 in (20 threads per inch) has a pitch of 0.050 in and a 1 ⁄ 13 in pitch (13 threads per inch) has a pitch of 0.077 in.

3. Carbide saw - Wikipedia

   en.wikipedia.org/wiki/Carbide_saw

   Depending on the size of the saw blades, a maximum of five gear sets with a gear reduction of up to 40:1 can be used. Variable speed motors of up to 150 KW drive the gearbox directly or via timing or "V" belts. Many saws have the blade mounting flange integrated within the spindle.

4. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   1.25 in (32 mm) hole saw bit. Hole saws take the form of a short open cylinder with saw-teeth on the open edge, used for making relatively large holes in thin material. They remove material only from the edge of the hole, cutting out an intact disc of material, unlike many drills which remove all material in the interior of the hole.

5. List of blade materials - Wikipedia

   en.wikipedia.org/wiki/List_of_blade_materials

   The blade is made of non-rustproof carbon steel, blue-plastered by hand and finely forged from the base to the tip of the knife. The 90 mm (3.5 in) long blade shows patina (dark spots) caused by decades of use. It can easily be sharpened to a shaving sharp edge. Carbon steel is a popular choice for rough-use knives and cheaper options.

6. Chainsaw - Wikipedia

   en.wikipedia.org/wiki/Chainsaw

   The end of the saw power head has two oil holes, one on each side. These holes must match with the outlet of the oil pump. The pump sends the oil through the hole in the lower part of the gauge. [citation needed] Saw bar producers provide a large variety of bars matching different saws. [citation needed]

7. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than ⁠ 1 / 4 ⁠ inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.