Search results
Results from the WOW.Com Content Network
The cam can be seen as a device that converts rotational motion to reciprocating (or sometimes oscillating) motion. [clarification needed] [3] A common example is the camshaft of an automobile, which takes the rotary motion of the engine and converts it into the reciprocating motion necessary to operate the intake and exhaust valves of the cylinders.
Cam lobe profiles often do not permit the spring to "put back" the energy into the camshaft because the lobe shape dictates the timing of the valve opening and closing, thus, the lobe is always working against the spring tension.
Since those days, lift, velocity, acceleration, and jerk curves for cams have been modelled by computer [6] to reveal that cam dynamics are not what they seemed. With proper analysis, problems relating to valve adjustment, hydraulic tappets , push rods, rocker arms, and above all, valve float , became things of the past without desmodromic drive.
A camshaft operating two valves. A camshaft is a shaft that contains a row of pointed cams in order to convert rotational motion to reciprocating motion.Camshafts are used in piston engines (to operate the intake and exhaust valves), [1] [2] mechanically controlled ignition systems and early electric motor speed controllers.
Pushrods are long, slender metal rods that are used in overhead valve engines to transfer motion from the camshaft (located in the engine block) to the valves (located in the cylinder head). The bottom end of a pushrod is fitted with a lifter, upon which the camshaft makes contact. The camshaft lobe moves the lifter upwards, which moves the ...
All these engines show their lineage by the characteristic un-skirted crankcase block of the BMC A-series, but with the A and E having the camshaft moved to the right side allowing greater port areas, and a mounting on the right wall of the crankcase for the oil pump, whereas the BMC A-series had the oil pump at the back end of the left-side ...
From January 2008 to December 2012, if you bought shares in companies when Donald R. Keough joined the board, and sold them when he left, you would have a 9.0 percent return on your investment, compared to a -2.8 percent return from the S&P 500.
The cams open (lift) the valves kind for a certain amount of time (duration) during each intake and exhaust cycle. The timing of the valve opening and closing, relative to the position of the crankshaft, is important. The camshaft is driven by the crankshaft through timing belts, gears or chains.