Search results
Results from the WOW.Com Content Network
A typical timber shear wall consists of braced panels in the wall line, constructed using structural plywood sheathing, specific nailing at the edges, and supporting framing. A shear wall is an element of a structurally engineered system that is designed to resist in-plane lateral forces, typically wind and seismic loads.
Face Veneer thickness-- For any three-ply construction, which applies to 3 and 4 mm material, each face veneer shall be not thinner than 1/8 of the total thickness of veneers assembled dry. Since the dry thicknesses of the boards are 3.6 and 4.6 respectively, we can assume that, for these thicknesses only, the face veneers will be as follows:
EPS is the most common of the foams used and has an R-value (thermal resistance) of about 4 °F·ft 2 ·h/Btu (equivalent to about 0.7 K·m 2 /W) per 25 mm thickness, which would give the 3.5 inches (89 mm) of foam in a 4.5-inch-thick (110 mm) panel an R value of 13.8 (caution: extrapolating R-values over thickness may be imprecise due to non ...
Thickness R-value R-value at 1 m (m 2 ... 11–20 Urea-formaldehyde panels 2.54: 1 0.88–1.06: ... such as sheathing 2.54: 1 0.44: 2.5: 17 (9 ...
The most commonly used thickness range is from 1 ⁄ 8 to 3 inches (3.2–76.2 mm). The sizes of the most commonly used plywood sheets are 4 by 8 feet (1,220 mm × 2,440 mm) [20] which was first used by the Portland Manufacturing Company, who developed modern veneer core plywood for the 1905 Portland World Fair. A common metric size for a sheet ...
In the United States, the International Building Code and ASTM International define Exterior Insulation and Finish System (EIFS) as a non-load-bearing exterior wall cladding system that consists of an insulation board attached either adhesively, mechanically, or both, to the substrate; an integrally reinforced base coat; and a textured protective finish coat.
Composite cladding typically consists of panels 3–5 millimetres (0.12–0.20 in) thick made of a core material sandwiched between two aluminium faces. The core material may be polyethylene (which is combustible), a mineral-based material, or a combination of both. Panels of the same appearance may have different core materials; those with a ...
Studs usually consist of 1 + 1 ⁄ 2-by-3 + 1 ⁄ 2-inch (38 mm × 89 mm) or 1 + 1 ⁄ 2-by-5 + 1 ⁄ 2-inch (38 mm × 140 mm) lumber and are commonly spaced at 16 inches (410 mm) on center. This spacing may be changed to 12 or 24 inches (300 or 610 mm) on center depending on the load and the limitations imposed by the type and thickness of the ...