enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Decibel - Wikipedia

    en.wikipedia.org/wiki/Decibel

    The decibel originates from methods used to quantify signal loss in telegraph and telephone circuits. Until the mid-1920s, the unit for loss was miles of standard cable (MSC). 1 MSC corresponded to the loss of power over one mile (approximately 1.6 km) of standard telephone cable at a frequency of 5000 radians per second (795.8 Hz), and matched closely the smallest attenuation detectable to a ...

  3. Signal-to-noise ratio - Wikipedia

    en.wikipedia.org/wiki/Signal-to-noise_ratio

    Signal-to-noise ratio (SNR or S/N) is a measure used in science and engineering that compares the level of a desired signal to the level of background noise. SNR is defined as the ratio of signal power to noise power, often expressed in decibels. A ratio higher than 1:1 (greater than 0 dB) indicates more signal than noise.

  4. Sound transmission class - Wikipedia

    en.wikipedia.org/wiki/Sound_transmission_class

    A 0.1% open area will reduce the transmission loss from 40 dB to 30 dB, which is typical of walls where caulking has not been applied effectively [26] Partitions that are inadequately sealed and contain back-to-back electrical boxes, untreated recessed lighting and unsealed pipes offer flanking paths for sound and significant leakage. [27]

  5. EPNdB - Wikipedia

    en.wikipedia.org/wiki/EPNdB

    Effective perceived noise in decibels (EPNdB) or Effective Perceived Noise Level (EPNL) is a measure of the relative noisiness of an individual aircraft pass-by event. It is used for aircraft noise certification and applies to an individual aircraft, not the noise exposure from an airport.

  6. Peak signal-to-noise ratio - Wikipedia

    en.wikipedia.org/wiki/Peak_signal-to-noise_ratio

    Peak signal-to-noise ratio (PSNR) is an engineering term for the ratio between the maximum possible power of a signal and the power of corrupting noise that affects the fidelity of its representation. Because many signals have a very wide dynamic range, PSNR is usually expressed as a logarithmic quantity using the decibel scale.

  7. Sound reduction index - Wikipedia

    en.wikipedia.org/wiki/Sound_Reduction_Index

    The Sound Reduction Index is expressed in decibels (dB). It is the weighted sound reduction index for a partition or single component only. This is a laboratory-only measurement, which uses knowledge of the relative sizes of the rooms in the test suite, and the reverberation time in the receiving room, and the known level of noise which can pass between the rooms in the suite by other routes ...

  8. Noise figure - Wikipedia

    en.wikipedia.org/wiki/Noise_figure

    The noise figure is the difference in decibel (dB) between the noise output of the actual receiver to the noise output of an "ideal" receiver with the same overall gain and bandwidth when the receivers are connected to matched sources at the standard noise temperature T 0 (usually 290 K).

  9. dBFS - Wikipedia

    en.wikipedia.org/wiki/DBFS

    Decibels relative to full scale (dBFS or dB FS) is a unit of measurement for amplitude levels in digital systems, such as pulse-code modulation (PCM), which have a defined maximum peak level. The unit is similar to the units dBov and decibels relative to overload (dBO). [1] The level of 0 dBFS is assigned to the maximum possible digital level. [2]