Search results
Results from the WOW.Com Content Network
A refresh rate of 60 Hz on most screens will produce a visible "flickering" effect. Most people find that refresh rates of 70–90 Hz and above enable flicker-free viewing on CRTs. Use of refresh rates above 120 Hz is uncommon, as they provide little noticeable flicker reduction and limit available resolution.
Flicker-free is a term given to video displays, primarily cathode ray tubes, operating at a high refresh rate to reduce or eliminate the perception of screen flicker.For televisions, this involves operating at a 100 Hz or 120 Hz hertz field rate to eliminate flicker, compared to standard televisions that operate at 50 Hz (PAL, SÉCAM systems) or 60 Hz (), most simply done by displaying each ...
The closest equivalent to a refresh rate on an LCD monitor is its frame rate, which is often locked at 60 fps. But this is rarely a problem, because the only part of an LCD monitor that could produce CRT-like flicker—its backlight—typically operates at around a minimum of 200 Hz.
Flicker: Perceptible on lower refresh rates (60 fps and below) [27] Depends; in 2013 most LCDs used PWM to dim the backlight [28] However, since then many flicker free LCD computer monitors were introduced. [29] Does not normally occur due to a high refresh rate higher than FPS [30] Does not normally occur at 100% brightness level.
Refresh rates get higher with each passing year, which makes it more complicated than ever to figure out what you actually need. 300-500Hz gaming monitors make up the high end of the spectrum, and ...
High resolution monochrome mode using a custom non-interlaced monitor with the slightly lower vertical resolution (in order to be an integer multiple of low and medium resolution and thus utilize the same amount of RAM for the framebuffer) allowing a "flicker free" 71.25 Hz refresh rate, higher even than the highest refresh rate provided by VGA.
These monitors ran at higher scanning frequencies, typically allowing a 75 to 90 Hz field rate (i.e. 37.5 to 45 Hz frame rate), and tended to use longer-persistence phosphors in their CRTs, all of which was intended to alleviate flicker and shimmer problems. Such monitors proved generally unpopular, outside of specialist ultra-high-resolution ...
Flicker can be noticed except at very high refresh rates, as each eye is effectively receiving only half of the monitor's actual refresh rate. However, modern LC glasses generally work in higher refresh rates and eliminate this problem for most people. First, the method only worked with CRT monitors.