Search results
Results from the WOW.Com Content Network
Surface tension is an important factor in the phenomenon of capillarity. Surface tension has the dimension of force per unit length, or of energy per unit area. [4] The two are equivalent, but when referring to energy per unit of area, it is common to use the term surface energy, which is a more general term in the sense that it applies also to ...
In the equation, m 1 and σ 1 represent the mass and surface tension of the reference fluid and m 2 and σ 2 the mass and surface tension of the fluid of interest. If we take water as a reference fluid, = If the surface tension of water is known which is 72 dyne/cm, we can calculate the surface tension of the specific fluid from the equation.
The surface is at constant depth, so the pressure is constant. Therefore, the integral of the pressure over the area of the horizontal bottom surface of the cube is the hydrostatic pressure at that depth multiplied by the area of the bottom surface. Similarly, the downward force on the cube is the pressure on the top surface integrated over its ...
In physics, the Young–Laplace equation (/ l ə ˈ p l ɑː s /) is an algebraic equation that describes the capillary pressure difference sustained across the interface between two static fluids, such as water and air, due to the phenomenon of surface tension or wall tension, although use of the latter is only applicable if assuming that the wall is very thin.
The interfacial (surface) tension, St, (dyne cm −1), can be calculated by applying the equation of capillary rise method (when the contact angle Ө → 0): = where: h (cm) is the height of Hg column above the Hg meniscus in the capillary; r (cm) is the radius of capillary
A: The bottom of a concave meniscus. B: The top of a convex meniscus. In physics (particularly fluid statics), the meniscus (pl.: menisci, from Greek 'crescent') is the curve in the upper surface of a liquid close to the surface of the container or another object, produced by surface tension.
where the surface tension-to-viscosity ratio [] represents the speed of ink penetration into the substrate. In reality, the evaporation of solvents limits the extent of liquid penetration in a porous layer and thus, for the meaningful modelling of inkjet printing physics it is appropriate to utilise models which account for evaporation effects ...
The case when the surface tension is present due to the effects of capillarity were also studied. [9] [10] Also, for the special case where surface tension and viscosity are neglected, high-order analytical approximations are also known. [11] In the static case, the Rayleigh–Plesset equation simplifies, yielding the Young–Laplace equation: