Search results
Results from the WOW.Com Content Network
A Boeing 737 uses an adjustable stabilizer, moved by a jackscrew, to provide the required pitch trim forces. Generic stabilizer illustrated. A horizontal stabilizer is used to maintain the aircraft in longitudinal balance, or trim: [3] it exerts a vertical force at a distance so the summation of pitch moments about the center of gravity is zero. [4]
A radio-controlled aircraft (often called RC aircraft or RC plane) is a small flying machine that is radio controlled by an operator on the ground using a hand-held radio transmitter. The transmitter continuously communicates with a receiver within the craft that sends signals to servomechanisms (servos) which move the control surfaces based on ...
Grumman F-14 Tomcat jet fighter during a takeoff, with stabilators deflected upwards. A stabilator is a fully movable aircraft horizontal stabilizer.It serves the usual functions of longitudinal stability, control and stick force requirements [1] otherwise performed by the separate parts of a conventional horizontal stabilizer (which is fixed) and elevator (which is adjustable).
The elevator is a usable up and down system that controls the plane, horizontal stabilizer usually creates a downward force which balances the nose down moment created by the wing lift force, which typically applies at a point (the wing center of lift) situated aft of the airplane's center of gravity.
The rear section of the tailplane is called the elevator, and is a movable aerofoil that controls changes in pitch, the up-and-down motion of the aircraft's nose. In some aircraft the horizontal stabilizer and elevator are one unit, and to control pitch the entire unit moves as one. This is known as a stabilator or full-flying stabiliser. [1] [2]
Basic aircraft control surfaces and motion. A)aileron B)control stick C)elevator D)rudder. Aircraft flight control surfaces are aerodynamic devices allowing a pilot to adjust and control the aircraft's flight attitude. Development of an effective set of flight control surfaces was a critical advance in the development of aircraft.
The four-point roll is a quick series of quarter rolls. The pilot gives four separate, but very brief aileron inputs. The first rolls the aircraft to knife-edge, the second rolls the aircraft inverted, the third rolls the aircraft to opposite knife-edge, and the final input rolls the aircraft back to upright.
1:10 scale radio-controlled car (Saab Sonett II)A radio-controlled model (or RC model) is a model that is steerable with the use of radio control (RC). All types of model vehicles have had RC systems installed in them, including ground vehicles, boats, planes, helicopters and even submarines and scale railway locomotives.