Search results
Results from the WOW.Com Content Network
While an ATX power supply is connected to the mains supply, it always provides a 5-volt standby (5VSB) power so that the standby functions on the computer and certain peripherals are powered. ATX power supplies are turned on and off by a signal from the motherboard. They also provide a signal to the motherboard to indicate when the DC voltages ...
The adapter typically supplies power to the device through a thin electrical cord which terminates in a coaxial power connector often referred to as a "barrel plug" (so-named because of its cylindrical shape). The polarity of the adapter cord and plug must match the polarity of the device, meaning that the positive contact of the plug must mate ...
An external power supply, AC adapter or power brick, is a power supply located in the load's AC power cord that plugs into a wall outlet; a wall wart is an external supply integrated with the outlet plug itself. These are popular in consumer electronics because of their safety; the hazardous 120 or 240 volt main current is transformed down to a ...
The CPU core voltage (V CORE) is the power supply voltage supplied to the processing cores of CPU (which is a digital circuit), GPU, or any other device with a processing core. The amount of power a CPU uses, and thus the amount of heat it dissipates, is the product of this voltage and the current it draws.
The label on a power supply may not be a reliable guide to the actual voltage it supplies under varying conditions. Many low-cost power supplies are "unregulated", in that their voltage can change considerably with load. If they are lightly loaded, they may put out much more than the nominal "name plate" voltage, which could damage the load.
#PS_ON pin is marked by number 16. PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM).
The ATX specification defines the Power-Good signal as a +5-volt (V) signal generated in the power supply when it has passed its internal self-tests and the outputs have stabilized. This normally takes between 0.1 and 0.5 seconds after the power supply is switched on.
In electronics, sense is a technique used in power supplies to produce the correct voltage for a load.Although simple batteries naturally maintain a steady voltage (except in cases of large internal impedance), a power supply must use a feedback system to make adjustments based on the difference between its intended output and its actual output.