enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Router (woodworking) - Wikipedia

   en.wikipedia.org/wiki/Router_(woodworking)

   Template guide bushing secured in the base around the router cutter. The tool usually consists of a base housing a vertically mounted universal electric motor with a collet on the end of its shaft. The bit is height-adjustable to allow protrusion through an opening in a flat sole plate, usually via adjusting the motor-mounting height (the ...

3. Collet - Wikipedia

   en.wikipedia.org/wiki/Collet

   Several machine collets (top and centre) and a dismantled pin chuck (below). Generally, a collet chuck, [3] considered as a unit, consists of a tapered receiving sleeve (sometimes integral with the machine spindle), the collet proper (usually made of spring steel) which is inserted into the receiving sleeve, and (often) a cap that screws over the collet, clamping it via another taper.

4. Wiggler (tool) - Wikipedia

   en.wikipedia.org/wiki/Wiggler_(tool)

   Centering of a shaft with a laser centering device. A centering device is a tool used to accurately adjust and align the center plane or axis of a work piece or work piece feature to the machining center. In contrast to the edge finder, it most often requires no calculation, measurements or layout method markings to allow this alignment.

5. CNC router - Wikipedia

   en.wikipedia.org/wiki/CNC_router

   A stone CNC router is a type of CNC router machine designed for marble, granite, artificial stone, tombstone, ceramic tiles, glass machining, polishing for arts and crafts, etc. Wood, metal and stone require different "bits" or "inserts".

6. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   The angle of the cone is 16°51′ (16.85°) with an OD of 1.25″ and a length of 15 ⁄ 16 ″. [21] (source, Bridgeport Manufacturer) The diameter of the parallel locating portion is not a "fractional inch" size like the other dimensions and is 0.949″ to 0.9495″. Tools with an R8 taper are inserted directly into the machine's spindle.

7. Combination square - Wikipedia

   en.wikipedia.org/wiki/Combination_square

   The heads, occasionally called anvils, are attached to the rule by sliding the rule into a slot in the side of the head. The head is then tightened in place via a lock bolt or lock nut which engages with a channel running the full length of the rule, allowing the head to be tightened on at any point along the rule.