Search results
Results from the WOW.Com Content Network
Atlas is a name for a family of modern inline piston engines for trucks from General Motors, used in the GMT355 and GMT360 platforms. The series debuted in 2002 with the Oldsmobile Bravada, and is also used in the Buick Rainier, the Chevrolet TrailBlazer and Colorado, the GMC Envoy and Canyon, the Hummer H3, Isuzu Ascender and i-370, and the Saab 9-7X.
The engines were also sold for marine and stationary applications. In a 1938 reorganization, Winton Engine Corporation became the GM Cleveland Diesel Engine Division, and GM's Detroit Diesel Engine Division began production of smaller (50–149 cu in (0.8–2.4 L) per cylinder) diesel engines. Locomotive engines were moved under the GM Electro ...
The straight-five engine (also referred to as an inline-five engine; abbreviated I5 or L5) is a piston engine with five cylinders mounted in a straight line along the crankshaft. Although less common than straight-four engines and straight-six engines , straight-five engine designs have been used by automobile manufacturers since the late 1930s.
Another common problem with the 2001–2006 5.3L engines was cracking cylinder heads. This is commonly called the "Castech Head" failure. GM issued a Technical Service Bulletin on this failure to help service technicians identify the problem. The head casting number (which can be viewed from the passenger side of the vehicle just in front of ...
Chevrolet Astro/GMC Safari. ... a Cadillac platform and given a 5.7-liter, 300-horsepower V8 Corvette engine that could pull 7,000 pounds. ... have sliding doors and had a four-cylinder engine ...
GMC replaced the Pontiac 223 with their own 228-cubic-inch (3.7 L) 228 in 1939. This OHV (overhead valve) engine was produced through 1953. With a cylinder bore of 3.5625 inches (90.49 mm), this is the smallest low-deck engine. All four low-deck engines have a stroke of 3.8125 inches (96.84 mm) and used 7 inch long connecting rods.
The upgraded engines, as built by model year 1981, were identified as "350 DX" on the block. [9] The later 4.3-liter V6 engine, which arrived for the 1982 model year, did not have the same problems as the V8. The V6 has a denser bolt pattern and Oldsmobile's engineers were given more time to develop and test it. [8]
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.