Search results
Results from the WOW.Com Content Network
A translinear circuit is a circuit that carries out its function using the translinear principle. These are current-mode circuits that can be made using transistors that obey an exponential current-voltage characteristic—this includes bipolar junction transistors (BJTs) and CMOS transistors in weak inversion.
CMOS inverter (a NOT logic gate). Complementary metal–oxide–semiconductor (CMOS, pronounced "sea-moss ", / s iː m ɑː s /, /-ɒ s /) is a type of metal–oxide–semiconductor field-effect transistor (MOSFET) fabrication process that uses complementary and symmetrical pairs of p-type and n-type MOSFETs for logic functions. [1]
The subthreshold slope is a feature of a MOSFET's current–voltage characteristic.. In the subthreshold region, the drain current behaviour—though being controlled by the gate terminal—is similar to the exponentially decreasing current of a forward biased diode.
Multi-threshold CMOS (MTCMOS) is a variation of CMOS chip technology which has transistors with multiple threshold voltages (V th) in order to optimize delay or power.The V th of a MOSFET is the gate voltage where an inversion layer forms at the interface between the insulating layer (oxide) and the substrate (body) of the transistor.
When the Wilson current mirror is used in CMOS circuits, it is usually in the four transistor form as in Fig. 5. [10] If the transistor pairs M1/M2 and M3/M4 are exactly matched and the input and output potentials are approximately equal, then in principle there is no static error, the input and output currents are equal because there is no low ...
In high performance CMOS (complementary metal–oxide–semiconductor) amplifier circuits, transistors are not only used to amplify the signal but are also used as active loads to achieve higher gain and output swing in comparison with resistive loads. [1] [2] [3] CMOS technology was introduced primarily for digital circuit design.
Transistor–transistor logic (TTL) is a logic family built from bipolar junction transistors.Its name signifies that transistors perform both the logic function (the first "transistor") and the amplifying function (the second "transistor"), as opposed to earlier resistor–transistor logic (RTL) and diode–transistor logic (DTL).
In a given technology node, such as the 90-nm CMOS process, the threshold voltage depends on the choice of oxide and on oxide thickness. Using the body formulas above, V T N {\displaystyle V_{TN}} is directly proportional to γ {\displaystyle \gamma } , and t O X {\displaystyle t_{OX}} , which is the parameter for oxide thickness.