Search results
Results from the WOW.Com Content Network
CMOS inverter (a NOT logic gate). Complementary metal–oxide–semiconductor (CMOS, pronounced "sea-moss ", / s iː m ɑː s /, /-ɒ s /) is a type of metal–oxide–semiconductor field-effect transistor (MOSFET) fabrication process that uses complementary and symmetrical pairs of p-type and n-type MOSFETs for logic functions. [1]
PTAT circuits using either BJT or CMOS transistors are widely used in temperature sensors (where we want the output to vary with temperature), and also in bandgap voltage references and other temperature-compensating circuits (where we want the same output at every temperature). [2] [3] [4]
Diode–transistor logic (DTL) was used in the IBM 608 which was the first all-transistorized computer. Early transistorized computers were implemented using discrete transistors, resistors, diodes and capacitors. The first diode–transistor logic family of integrated circuits was introduced by Signetics in 1962.
In high performance CMOS (complementary metal–oxide–semiconductor) amplifier circuits, transistors are not only used to amplify the signal but are also used as active loads to achieve higher gain and output swing in comparison with resistive loads. [1] [2] [3] CMOS technology was introduced primarily for digital circuit design.
DRAM chips during the early 1970s had three-transistor cells, before single-transistor cells became standard since the mid-1970s. [17] [15] CMOS memory was commercialized by RCA, which launched a 288-bit CMOS SRAM memory chip in 1968. [23] CMOS memory was initially slower than NMOS memory, which was more widely used by computers in the 1970s. [24]
In general, dynamic logic greatly increases the number of transistors that are switching at any given time, which increases power consumption over static CMOS. [8] There are several power-saving techniques that can be implemented in a dynamic logic based system. In addition, each rail can convey an arbitrary number of bits, and there are no ...
Multi-threshold CMOS (MTCMOS) is a variation of CMOS chip technology which has transistors with multiple threshold voltages (V th) in order to optimize delay or power.The V th of a MOSFET is the gate voltage where an inversion layer forms at the interface between the insulating layer (oxide) and the substrate (body) of the transistor.
M5 and M6 are bidirectional pass transistors. a 10-transistor CMOS gated D latch, similar to the ones in the CD4042 or the CD74HC75 integrated circuits. Pass transistor logic often uses fewer transistors, runs faster, and requires less power than the same function implemented with the same transistors in fully complementary CMOS logic. [3]