Search results
Results from the WOW.Com Content Network
As the name suggests, an acre-foot is defined as the volume of one acre of surface area to a depth of one foot. Since an acre is defined as a chain by a furlong (i.e. 66 ft × 660 ft or 20.12 m × 201.17 m), an acre-foot is 43,560 cubic feet (1,233.5 m 3). There has been two definitions of the acre-foot (differing by about 0.0006%), using ...
22,956.841139 acre feet 6.228835459×10 9 imperial gallons Alternatively, 35.32 tmcft = 1 cubic kilometer (km 3 ) is the standard unit used by Central Water Commission of Government of India for reporting gross and effective storage capacities of dams in India in National Register of Large Dams (NRLD).
The acre (/ ˈ eɪ k ər / AY-kər) is a unit of land area used in the British imperial and the United States customary systems. It is traditionally defined as the area of one chain by one furlong (66 by 660 feet ), which is exactly equal to 10 square chains, 1 ⁄ 640 of a square mile, 4,840 square yards, or 43,560 square feet, and ...
If water falls uniformly over a field such that field capacity of the soil is not exceeded, then negligible water percolates to groundwater. If instead water puddles in low-lying areas, the same water volume concentrated over a smaller area may exceed field capacity resulting in water that percolates down to recharge groundwater.
The miner’s inch measures the amount of water that would flow through a slot of a given area at a given pressure (for example, at a head of 6 inches of water, or 1.5 kPa.) In miner's inch the word inch refers to the area of the slot in square inches, while the pressure in inches of water refers to the height of water above the slot. A ...
Theoretically, Hooghoudt's equation can also be used for sloping land. [8] The theory on drainage of sloping land is corroborated by the results of sand tank experiments. [9] In addition, the entrance resistance encountered by the water upon entering the drains can be accounted for. Definitions of drainage of sloping land and entrance resistance
The acre is also commonly used to measure land areas, where 1 acre = 4,840 square yards = 43,560 square feet. An acre is approximately 40% of a hectare. On the atomic scale, area is measured in units of barns, such that: [13] 1 barn = 10 −28 square meters. The barn is commonly used in describing the cross-sectional area of interaction in ...
The amount of land needed is in proportion to the size of the septic system and the soil conditions, which must allow for the percolation of wastewater safely into the ground. In areas where well water is used, additional lot area may be required to sufficiently separate the well from the leach field.