enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Printed circuit board milling - Wikipedia

   en.wikipedia.org/wiki/Printed_circuit_board_milling

   A milled printed circuit board. Printed circuit board milling (also: isolation milling) is the milling process used for removing areas of copper from a sheet of printed circuit board (PCB) material to recreate the pads, signal traces and structures according to patterns from a digital circuit board plan known as a layout file. [1]

3. Printed circuit board - Wikipedia

   en.wikipedia.org/wiki/Printed_circuit_board

   A printed circuit board (PCB), also called printed wiring board (PWB), is a laminated sandwich structure of conductive and insulating layers, each with a pattern of traces, planes and other features (similar to wires on a flat surface) etched from one or more sheet layers of copper laminated onto or between sheet layers of a non-conductive ...

4. Point-to-point construction - Wikipedia

   en.wikipedia.org/wiki/Point-to-point_construction

   Section of a typical Australian late 1930s radio, showing the point to point construction between components. In electronics, point-to-point construction is a non-automated technique for constructing circuits which was widely used before the use of printed circuit boards (PCBs) and automated assembly gradually became widespread following their introduction in the 1950s.

5. Category:Printed circuit board manufacturing - Wikipedia

   en.wikipedia.org/wiki/Category:Printed_circuit...

   Pages in category "Printed circuit board manufacturing" The following 76 pages are in this category, out of 76 total. This list may not reflect recent changes .

6. Coupon (PWB) - Wikipedia

   en.wikipedia.org/wiki/Coupon_(PWB)

   A coupon or test coupon is a printed circuit board (PCB) used to test the quality of a printed wiring board (PWB) fabrication process. Test coupons are fabricated on the same panel as the PWBs, typically at the edges. Coupons are then inspected to ensure proper layer alignment, electrical connectivity, and cross sectioned to inspect internal ...

7. Chip on board - Wikipedia

   en.wikipedia.org/wiki/Chip_on_board

   The PCB of a quartz watch. The clock IC is under the drop of black epoxy. Chip on board (COB) is a method of circuit board manufacturing in which the integrated circuits (e.g. microprocessors) are attached (wired, bonded directly) to a printed circuit board, and covered by a blob of epoxy. [1]