enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Twin-Traction Beam - Wikipedia

   en.wikipedia.org/wiki/Twin-Traction_Beam

   Twin-Traction Beam was invented by John A. Richardson and Donald G. Wheatley of Ford Motor Company covered by US patent 3,948,337 issued April 6, 1976. The patent name was “Independent front suspension for front-wheel drive” which was assigned to Ford Motor Company. [1] [2] The Dana Holding Corporation manufactured

3. RevoKnuckle - Wikipedia

   en.wikipedia.org/wiki/RevoKnuckle

   RevoKnuckle is a variation of the MacPherson strut suspension design by Ford which separates steering and suspension movements to provide lower scrub radius [1] and kingpin offset than traditional MacPherson struts.

4. Control arm - Wikipedia

   en.wikipedia.org/wiki/Control_arm

   MacPherson strut suspension, track control arm coloured dark blue. In automotive suspension, a control arm, also known as an A-arm, is a hinged suspension link between the chassis and the suspension upright or hub that carries the wheel. In simple terms, it governs a wheel's vertical travel, allowing it to move up or down when driving over ...

5. Transverse leaf spring front suspension - Wikipedia

   en.wikipedia.org/wiki/Transverse_leaf_spring...

   1919 Ford Model T. Transverse leaf spring front suspension is a type of automotive front suspension, whose usage is most well known in Ford Motor Company products from 1908 to 1948 (1959 for the inexpensive Ford Popular in the UK). "Suicide front axle" is a term that has been used for it.

6. Independent suspension - Wikipedia

   en.wikipedia.org/wiki/Independent_suspension

   A multi-link type rear independent suspension on an AWD car. The anti-roll bar has some yellow paint on it. Independent suspension is any automobile suspension system that allows each wheel on the same axle to move vertically (i.e. reacting to a bump on the road) independently of the others.

7. Steering knuckle - Wikipedia

   en.wikipedia.org/wiki/Steering_knuckle

   The wheel and tire assembly attach to the hub or spindle of the knuckle where the tire/wheel rotates while being held in a stable plane of motion by the knuckle/suspension assembly. In the attached photograph of a double-wishbone suspension, the knuckle is shown attached to the upper control arm at the top and the lower control arm at the bottom.