Search results
Results from the WOW.Com Content Network
For a successful design, the realized safety factor must always equal or exceed the design safety factor so that the margin of safety is greater than or equal to zero. The margin of safety is sometimes, but infrequently, used as a percentage, i.e., a 0.50 MS is equivalent to a 50% MS.
The false positive rate (FPR) is the proportion of all negatives that still yield positive test outcomes, i.e., the conditional probability of a positive test result given an event that was not present. The false positive rate is equal to the significance level. The specificity of the test is equal to 1 minus the false positive rate.
Electronic tensiometer probe: (1) porous cup; (2) water-filled tube; (3) sensor-head; (4) pressure sensor. At any point above the water table, in the vadose zone, the effective stress is approximately equal to the total stress, as proven by Terzaghi's principle. Realistically, the effective stress is greater than the total stress, as the pore ...
Thus is the shear stress acting on the face with normal vector in the positive direction of the -axis, and in the positive direction of the -axis. In the physical-space sign convention, positive normal stresses are outward to the plane of action (tension), and negative normal stresses are inward to the plane of action (compression) (Figure 5).
This type of stress may be called (simple) normal stress or uniaxial stress; specifically, (uniaxial, simple, etc.) tensile stress. [13] If the load is compression on the bar, rather than stretching it, the analysis is the same except that the force F and the stress change sign, and the stress is called compressive stress.
Other workplace stressors included: Length of work day/week: (7 percent); personal well-being in danger (5 percent); potential for promotion (3 percent); and travel (1 percent).
In continuum mechanics, hydrostatic stress, also known as isotropic stress or volumetric stress, [1] is a component of stress which contains uniaxial stresses, but not shear stresses. [2] A specialized case of hydrostatic stress contains isotropic compressive stress, which changes only in volume, but not in shape. [ 1 ]
[1]: 58 For example, low-carbon steel generally exhibits a very linear stress–strain relationship up to a well-defined yield point. The linear portion of the curve is the elastic region, and the slope of this region is the modulus of elasticity or Young's modulus .