Search results
Results from the WOW.Com Content Network
The Quadra-Drive system was introduced in 1999 and is based on the Quadra-Trac II system but adds gerotor differentials to the front and rear axles to create a four-wheel drive system capable of not only directing torque to the axle with the better traction but to the individual wheel on an axle with better traction.
R4 layout, the engine is located behind the rear axle. In automotive design, an R4, or rear-engine, four-wheel-drive layout places the engine at the rear of the vehicle, and drives all four roadwheels. This layout is typically chosen to improve the traction or the handling of existing vehicle designs using the rear-engine, rear-wheel-drive ...
Jeep with plow attachment in 1949 matchbook cover art. The Willys-Overland CJ-3A was introduced in 1949, and was in production until 1953, when replaced by the CJ-3B. It was powered by Willys' 60 hp (45 kW; 61 PS) L-134 Go-Devil four-cylinder engine, with a T-90 transmission and Dana 18 transfer case, a Dana 25 front axle and Dana 41 or 44 rear ...
Quadra-Trac II was available on models equipped with a V8 engine; it is a full-time system as well but adds a low range as well as a neutral position for towing. Quadra-Drive II expands on Quadra-Trac II by adding electronic limited slip differentials to the front and rear axles. When equipped with Quadra-Drive II, skid plates for the fuel tank ...
RR layout. In automotive design, an RR, or rear-engine, rear-wheel-drive layout places both the engine and drive wheels at the rear of the vehicle. In contrast to the RMR layout, the center of mass of the engine is between the rear axle and the rear bumper.
The output for the front drive shaft is on the right side and the rear output is in line with the input. This enables 2-wheel High to be direct-drive, which is quieter. Otherwise the Dana 20 offers the same drive modes as the Dana 18. Its low range has a ratio of 2.03:1. The Dana 20 is generally compatible with the "big hole" Dana 18.
The Jeep Forward Control is a truck that was produced by Willys Motors, later named Kaiser Jeep, from 1956 to 1965. It was also assembled in other international markets. It was also assembled in other international markets.
/ = the fore of the rear axles is steered (pusher axle) * = the rearmost of the rear axles is steered (tag axle) C = number of steered wheels - = separates axle groups and/or different axle functions (6x4-2 is 6x6 with undriven rear axle) Basis is always the standard configuration, meaning a steered front axle and a non-steered driven rear axle.