Search results
Results from the WOW.Com Content Network
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
Hexagonal (generally abbreviated to "hex") head widths (width across flats, spanner size) are for DIN 934 hex nuts and hex head bolts. Other (usually smaller) sizes may occur to reduce weight or cost, including the small series flange bolts defined in ISO 4162 which typically have hexagonal head sizes corresponding to the smaller 1st choice ...
The major diameter is given by 6p 1.2, [4]: 12 rounded to two significant figures in mm and the hex head size (across the flats) is 1.75 times the major diameter. BA sizes are specified by the following British Standards: BS 57:1951 — B.A. screws, bolts and nuts
The minimum limits for external (or bolt, in ISO terminology), and the maximum limits for internal (nut), thread sizes are there to ensure that threads do not strip at the tensile strength limits for the parent material. The minimum limits for internal, and maximum limits for external, threads are there to ensure that the threads fit together.
Standard Name Type Example ASME B1.1-2003 (R2018) Unified Inch Screw Threads (UN and UNR Thread Form) V Thread Form: 1 ⁄ 4 ″-20 UNC #4-40 UNC ASME B1.5-1997 (R2014) Acme Screw Threads: Trapezoidal Thread Form: Tr 60×9 ANSI/ASME B1.9-1973 (R2017) Buttress Inch Screw Threads: Breech-Lock Thread Form: ASME B1.10M-2004 (R2014) Unified ...
Product grade A washers – with a hardness up to 300 HV designed for use with hexagon head bolts and nuts: Withdrawn: DIN EN ISO 7089, DIN EN ISO 7090: ISO 7089, ISO 7090: DIN 126: Product grade C washers – designed for use with hexagon head bolts and nut: Withdrawn: DIN EN ISO 7091: ISO 7091: DIN 127: Spring lock washers with square ends or ...
British Standard Whitworth (BSW) is an imperial-unit-based screw thread standard, devised and specified by Joseph Whitworth in 1841 and later adopted as a British Standard. It was the world's first national screw thread standard, and is the basis for many other standards, such as BSF , BSP , BSCon , and BSCopper .
This standard is the origin for other standards that define properties for similar metric fasteners, such as SAE J1199 and ASTM F568M. [1] It is divided into five (nonconsecutive) parts: 1. Bolts, screws and studs with specified property classes – Coarse thread and fine pitch thread [2] 2. Nuts with specified proof load values – Coarse ...