Search results
Results from the WOW.Com Content Network
In the floating-point case, a variable exponent would represent the power of ten to which the mantissa of the number is multiplied. Languages that support a rational data type usually allow the construction of such a value from two integers, instead of a base-2 floating-point number, due to the loss of exactness the latter would cause.
On some PowerPC systems, [11] long double is implemented as a double-double arithmetic, where a long double value is regarded as the exact sum of two double-precision values, giving at least a 106-bit precision; with such a format, the long double type does not conform to the IEEE floating-point standard.
The actual size and behavior of floating-point types also vary by implementation. The only requirement is that long double is not smaller than double, which is not smaller than float. Usually, the 32-bit and 64-bit IEEE 754 binary floating-point formats are used for float and double respectively.
The hardware to manipulate these representations is less costly than floating point, and it can be used to perform normal integer operations, too. Binary fixed point is usually used in special-purpose applications on embedded processors that can only do integer arithmetic, but decimal fixed point is common in commercial applications.
A floating-point variable can represent a wider range of numbers than a fixed-point variable of the same bit width at the cost of precision. A signed 32-bit integer variable has a maximum value of 2 31 − 1 = 2,147,483,647, whereas an IEEE 754 32-bit base-2 floating-point variable has a maximum value of (2 − 2 −23) × 2 127 ≈ 3.4028235 ...
Double-precision floating-point format (sometimes called FP64 or float64) is a floating-point number format, usually occupying 64 bits in computer memory; it represents a wide range of numeric values by using a floating radix point. Double precision may be chosen when the range or precision of single precision would be insufficient.
C# 3.0 introduced type inference, allowing the type specifier of a variable declaration to be replaced by the keyword var, if its actual type can be statically determined from the initializer. This reduces repetition, especially for types with multiple generic type-parameters , and adheres more closely to the DRY principle.
This odd behavior is caused by an implicit conversion of i_value to float when it is compared with f_value. The conversion causes loss of precision, which makes the values equal before the comparison. Important takeaways: float to int causes truncation, i.e., removal of the fractional part. double to float causes rounding of digit.