Search results
Results from the WOW.Com Content Network
Propane is commonly used in theme parks and in movie production as an inexpensive, high-energy fuel for explosions and other special effects. Propane is used as a propellant, relying on the expansion of the gas to fire the projectile. It does not ignite the gas. The use of a liquefied gas gives more shots per cylinder, compared to a compressed gas.
A hot rich flashover occurs when the hot smoke with flammable gas ratio above the upper limit of flammability range and temperature higher than the ignition temperature leaves the compartment. Upon dilution with air it can spontaneously ignite, and the resultant flame can propagate back into the compartment, resulting in an event similar to a ...
While water is used on Class A fires, using water on a Class B fire (e.g., a grease fire) is extremely dangerous. [3] [5] This is because Class B fires typically have a fuel with a lower density than water (causing it to rise) and the burning fluid is hotter than the boiling point of water (212 °F or 100 °C).
The water is heated and then routed into a reduced-pressure flash evaporation "stage" where some of the water flashes into steam. This steam is subsequently condensed into salt-free water. The residual salty liquid from that first stage is introduced into a second flash evaporation stage at a pressure lower than the first stage pressure.
This is achieved by maintaining a supply of fuel to the fire, monitoring the smoke from the fire and controlling it by the use of primary air through the fire bed/grate and secondary air through the firebox door and maintaining the boiler water level by use of steam injectors so that it covers the firebox crown sheet at all times – otherwise ...
Here is Our Hot Lunch How-to: Open up the clean container. Heat enough water to fit in the container to warm, or use warm tap water. Pour the warm water in the container about 1 inch below where ...
Propane Iso-Octane (2,2,4-Trimethylpentane) In daily life, the vast majority of flames one encounters are those caused by rapid oxidation of hydrocarbons in materials such as wood, wax, fat, plastics, propane, and gasoline. The constant-pressure adiabatic flame temperature of such substances in air is in a relatively narrow range around 1,950 ...
For buildings with one or two floors, h is the height of the building. For multi-floor, high-rise buildings, h is the distance from the openings at the neutral pressure level (NPL) of the building to either the topmost openings or the lowest openings. Reference [10] explains how the NPL affects the stack effect in high-rise buildings.