Search results
Results from the WOW.Com Content Network
Propane is commonly used in theme parks and in movie production as an inexpensive, high-energy fuel for explosions and other special effects. Propane is used as a propellant, relying on the expansion of the gas to fire the projectile. It does not ignite the gas. The use of a liquefied gas gives more shots per cylinder, compared to a compressed gas.
A hot rich flashover occurs when the hot smoke with flammable gas ratio above the upper limit of flammability range and temperature higher than the ignition temperature leaves the compartment. Upon dilution with air it can spontaneously ignite, and the resultant flame can propagate back into the compartment, resulting in an event similar to a ...
The water is heated and then routed into a reduced-pressure flash evaporation "stage" where some of the water flashes into steam. This steam is subsequently condensed into salt-free water. The residual salty liquid from that first stage is introduced into a second flash evaporation stage at a pressure lower than the first stage pressure.
While water is used on Class A fires, using water on a Class B fire (e.g., a grease fire) is extremely dangerous. [3] [5] This is because Class B fires typically have a fuel with a lower density than water (causing it to rise) and the burning fluid is hotter than the boiling point of water (212 °F or 100 °C).
The flashback arrestors are suitable for most technical gases (fuel gases) such as acetylene, hydrogen, methane, propane, propylene and butane as well as oxygen and compressed air. Flashback arrestors have to be tested for gas non-return, for tightness and for gas flow by a qualified person depending on the country specific regulations.
Heat enough water to fit in the container to warm, or use warm tap water. Pour the warm water in the container about 1 inch below where the lid sits. You do not want the lid to cause the boiling ...
Propane Iso-Octane (2,2,4-Trimethylpentane) In daily life, the vast majority of flames one encounters are those caused by rapid oxidation of hydrocarbons in materials such as wood, wax, fat, plastics, propane, and gasoline. The constant-pressure adiabatic flame temperature of such substances in air is in a relatively narrow range around 1,950 ...
Propane does not burn as hot as acetylene in its inner cone, and so it is rarely used for welding. [12] Propane, however, has a very high number of BTUs per cubic foot in its outer cone, and so with the right torch ( injector style ) can make a faster and cleaner cut than acetylene, and is much more useful for heating and bending than acetylene.