enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Engineering fit - Wikipedia

   en.wikipedia.org/wiki/Engineering_fit

   Engineering fits are generally used as part of geometric dimensioning and tolerancing when a part or assembly is designed. In engineering terms, the "fit" is the clearance between two mating parts, and the size of this clearance determines whether the parts can, at one end of the spectrum, move or rotate independently from each other or, at the other end, are temporarily or permanently joined.

3. Lathe - Wikipedia

   en.wikipedia.org/wiki/Lathe

   Modern metal lathe A watchmaker using a lathe to prepare a component cut from copper for a watch. A lathe (/ l eɪ ð /) is a machine tool that rotates a workpiece about an axis of rotation to perform various operations such as cutting, sanding, knurling, drilling, deformation, facing, threading and turning, with tools that are applied to the workpiece to create an object with symmetry about ...

4. DMC DeLorean - Wikipedia

   en.wikipedia.org/wiki/DMC_DeLorean

   The engine has a 91 mm (3.6 in) bore and 73 mm (2.9 in) stroke, a compression ratio of 8.8:1 and was fitted with a Bosch K-Jetronic fuel injection system. [ 7 ] Two transmissions were available for the DeLorean: a 5-speed manual and a 3-speed automatic , both with a final drive ratio of 3.44:1.

5. Drill - Wikipedia

   en.wikipedia.org/wiki/Drill

   A standard hammer drill accepts 6 mm (1/4 inch) and 13 mm (1/2 inch) drill bits. The operator experiences considerable vibration, and the cams are generally made from hardened steel to avoid them wearing out quickly. In practice, drills are restricted to standard masonry bits up to 13 mm (1/2 inch) in diameter.

6. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   In many lathe tailstocks, the tool is removed by fully withdrawing the quill into the tailstock, which brings the tool up against the end of the leadscrew or an internal stud, separating the taper and releasing the tool. Where the tool is retained by a drawbar, as in some mill spindles, the drawbar is partially unthreaded with a wrench and then ...

7. List of Wheeler Dealers episodes - Wikipedia

   en.wikipedia.org/wiki/List_of_Wheeler_Dealers...

   Work Completed: Tiptronic transmission oil and filter changed to sort out slipping first gear in automatic mode, all four brake discs skimmed with on-car brake lathe and brake pads replaced, both catalytic converters replaced with aftermarket units due to rusted and rattling heat shields, exhaust back box changed with a stainless steel ...