Search results
Results from the WOW.Com Content Network
A series circuit with a voltage source (such as a battery, or in this case a cell) and three resistance units. Two-terminal components and electrical networks can be connected in series or parallel. The resulting electrical network will have two terminals, and itself can participate in a series or parallel topology.
The L network relies on a procedure known as series-parallel transformation. For every series combination of resistance, R S, and reactance, X S, there exists a parallel combination of R P and X P that acts identically to the voltage applied across the series combination. In other words, the series components and the parallel components provide ...
This can be calculated from the Z L of the loudspeaker (typically 2, 4, or 8 ohms) and the given value of the damping factor. Generally in audio and hifi , the input impedance of components is several times (technically, more than 10) the output impedance of the device connected to them.
A network with two components or branches has only two possible topologies: series and parallel. Figure 1.2. Series and parallel topologies with two branches. Even for these simplest of topologies, the circuit can be presented in varying ways. Figure 1.3. All these topologies are identical. Series topology is a general name.
American EIA standard RS-299A specifies that (or DCR) should be at least 80% of the rated driver impedance, so an 8-ohm rated driver should have a DC resistance of at least 6.4 ohms, and a 4-ohm unit should measure 3.2 ohms minimum. This standard is voluntary, and many 8-ohm drivers have resistances of ≈5.5 ohms, and proportionally lower for ...
Norton's theorem and its dual, Thévenin's theorem, are widely used for circuit analysis simplification and to study circuit's initial-condition and steady-state response. Norton's theorem was independently derived in 1926 by Siemens & Halske researcher Hans Ferdinand Mayer (1895–1980) and Bell Labs engineer Edward Lawry Norton (1898–1983).
The expression series-parallel can apply to different domains: Series and parallel circuits for electrical circuits and electronic circuits; Series-parallel partial order, in partial order theory; Series–parallel graph in graph theory; Series–parallel networks problem, a combinatorial problem about series–parallel graphs
Constant-voltage speaker systems are also commonly referred to as 25-, 70-, 70.7-, 100 or 210-volt speaker systems; distributed speaker systems; or high-impedance speaker systems. In Canada and the US, they are most commonly referred to as 70-volt speakers. In Europe, the 100 V system is the most widespread, with amplifier and speaker products ...