Search results
Results from the WOW.Com Content Network
2.54 cm – 1 inch; 3.08568 cm – 1 attoparsec; 3.4 cm – length of a quail egg [112] 3.5 cm – width of film commonly used in motion pictures and still photography; 3.78 cm – amount of distance the Moon moves away from Earth each year [113] 4.3 cm – minimum diameter of a golf ball [114] 5 cm – usual diameter of a chicken egg
The corresponding metric inch of 25 millimetres (0.984 in) was used for pin spacing in Soviet microchips, which were often cloned from Western designs but scaled down slightly from US customary inches to metric inches. This led to incompatibility issues in the Soviet computer market. [9]
Parsecs are used in astronomy to measure interstellar distances. A parsec is approximately 3.26 light-years or about 3.086×10 16 m (1.917×10 13 mi). Combining it with the "atto-" prefix (×10 −18) yields attoparsec (apc), a conveniently human-scaled unit of about 3.086 centimetres (1.215 in) that is used only humorously. [7]
The metric system is a system of measurement that standardizes a set of base units and a nomenclature for describing relatively large and small quantities via decimal-based multiplicative unit prefixes.
There are two other measures of susceptibility, the molar magnetic susceptibility (χ m) with unit m 3 /mol, and the mass magnetic susceptibility (χ ρ) with unit m 3 /kg that are defined below, where ρ is the density with unit kg/m 3 and M is molar mass with unit kg/mol: =; = =.
In 1859 Lombardy (but not Venetia) was annexed. In 1860 Parma, Modena, Tuscany, Umbria, Romagna and the Marches, and the Two Sicilies (Naples) were assimilated into Sardinia and under the Law 132 of 28 July 28, 1861 the metric system became the official system of measurement throughout the (this year) Italian kingdom. [3]
For example, a 12-inch-long coil (ℓ = 12 in) with a long plunger with a cross section of one inch square (A = 1 in 2) and 11,200 ampere-turns (N I = 11,200 Aturn) had a maximum pull of 8.75 pounds (corresponding to C = 0.0094 psi). [10] The maximum pull is increased when a magnetic stop is inserted into the solenoid.
Originally in 1945, the divisions were based on the ring inside diameter in steps of 1 ⁄ 64 inch (0.40 mm). [6] However, in 1987 BSI updated the standard to the metric system so that one alphabetical size division equals 1.25 mm of circumferential length.