enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Servo control - Wikipedia

   en.wikipedia.org/wiki/Servo_control

   Servo and receiver connections A diagram showing typical PWM timing for a servomotor. Servo control is a method of controlling many types of RC/hobbyist servos by sending the servo a PWM (pulse-width modulation) signal, a series of repeating pulses of variable width where either the width of the pulse (most common modern hobby servos) or the duty cycle of a pulse train (less common today ...

3. Servo (radio control) - Wikipedia

   en.wikipedia.org/wiki/Servo_(radio_control)

   The servo is controlled by three wires: ground, power, and control. The servo will move based on the pulses sent over the control wire, which set the angle of the actuator arm. The servo expects a pulse every 20 ms in order to gain correct information about the angle. The width of the servo pulse dictates the range of the servo's angular motion.

4. Servomechanism - Wikipedia

   en.wikipedia.org/wiki/Servomechanism

   A standard RC receiver (or a microcontroller) sends pulse-width modulation (PWM) signals to the servo. The electronics inside the servo translate the width of the pulse into a position. When the servo is commanded to rotate, the motor is powered until the potentiometer reaches the value corresponding to the commanded position.

5. Servomotor - Wikipedia

   en.wikipedia.org/wiki/Servomotor

   A servomotor (or servo motor or simply servo) [1] is a rotary or linear actuator that allows for precise control of angular or linear position, velocity, and acceleration in a mechanical system. [ 1 ] [ 2 ] It constitutes part of a servomechanism , and consists of a suitable motor coupled to a sensor for position feedback and a controller ...

6. Pulse-position modulation - Wikipedia

   en.wikipedia.org/wiki/Pulse-position_modulation

   Servos made for model radio control include some of the electronics required to convert the pulse to the motor position – the receiver is required to first extract the information from the received radio signal through its intermediate frequency section, then demultiplex the separate channels from the serial stream, and feed the control ...

7. Radio-controlled model - Wikipedia

   en.wikipedia.org/wiki/Radio-controlled_model

   1:10 scale radio-controlled car (Saab Sonett II)A radio-controlled model (or RC model) is a model that is steerable with the use of radio control (RC). All types of model vehicles have had RC systems installed in them, including ground vehicles, boats, planes, helicopters and even submarines and scale railway locomotives.

8. Servo drive - Wikipedia

   en.wikipedia.org/wiki/Servo_drive

   OEM servo drive from INGENIA installed on CNC router machine controlling a Faulhaber motor. Servo systems can be used in CNC machining, factory automation, and robotics, among other uses. Their main advantage over traditional DC or AC motors is the addition of motor feedback. This feedback can be used to detect unwanted motion, or to ensure the ...

9. RC oscillator - Wikipedia

   en.wikipedia.org/wiki/RC_oscillator

   RC oscillators are a type of feedback oscillator; they consist of an amplifying device, a transistor, vacuum tube, or op-amp, with some of its output energy fed back into its input through a network of resistors and capacitors, an RC network, to achieve positive feedback, causing it to generate an oscillating sinusoidal voltage.