Search results
Results from the WOW.Com Content Network
Values of thermal conductivities for various materials are listed in the list of thermal conductivities. As mentioned earlier in the article the convection heat transfer coefficient for each stream depends on the type of fluid, flow properties and temperature properties. Some typical heat transfer coefficients include: Air - h = 10 to 100 W/(m 2 K)
The rate of heat flow is the amount of heat that is transferred per unit of time in some material, usually measured in watts (joules per second). Heat is the flow of thermal energy driven by thermal non-equilibrium, so the term 'heat flow' is a redundancy (i.e. a pleonasm). Heat must not be confused with stored thermal energy, and moving a hot ...
When talking about the efficiency of heat engines and power stations the convention should be stated, i.e., HHV (a.k.a. Gross Heating Value, etc.) or LCV (a.k.a. Net Heating value), and whether gross output (at the generator terminals) or net output (at the power station fence) are being considered. The two are separate but both must be stated.
Although the concept of U-value (or U-factor) is universal, U-values can be expressed in different units. In most countries, U-value is expressed in SI units, as watts per square metre-kelvin: W/(m 2 ⋅K) In the United States, U-value is expressed as British thermal units (Btu) per hour-square feet-degrees Fahrenheit: Btu/(h⋅ft 2 ⋅°F)
Values in parentheses are extrapolated, interpolated, or estimated. *It happens that the online record has the thermal conductivity at 30 Kelvins and ∥ {\displaystyle \parallel } to the c axis posted at 1.36 W⋅cm −1 K −1 and 78.0 Btu hr −1 ft −1 F −1 which is incorrect.
The values are organized in a format that makes them readable by a thermodynamic calculation program or for use in a spreadsheet. For example, the Excel -based thermodynamic database FREED [1] creates the following type of datafile, here for a standard pressure of 1 atm.
Q is the exchanged heat duty , U is the heat transfer coefficient (watts per kelvin per square meter), A is the exchange area. Note that estimating the heat transfer coefficient may be quite complicated. This holds both for cocurrent flow, where the streams enter from the same end, and for countercurrent flow, where they enter from different ends.
The usual reason for the limit is heat, and the maximum heat dissipation is calculated as above. Power ratings are usually given in watts for real power and volt-amperes for apparent power , although for devices intended for use in large power systems, both may be given in a per-unit system .