Search results
Results from the WOW.Com Content Network
Regenerative receivers require fewer components than other types of receiver circuit, such as the TRF and superheterodyne. The circuit's advantage was that it got much more amplification (gain) out of the expensive vacuum tubes , thus reducing the number of tubes required and therefore the cost of a receiver.
The regenerative receiver also had its heyday at the time where adding an active element (vacuum tube) was considered costly. In order to increase the gain of the receiver, positive feedback was used in its single RF amplifier stage; this also increased the selectivity of the receiver well beyond what would be expected from a single tuned circuit.
Panadapters / Receivers Host Interface Windows Linux Mac FPGA Aaronia SPECTRAN V6 ECO [1] €2,498 EUR Pre-built Active 9 kHz – 8 GHz Up to 120 MHz (2 Rx with 60 MHz each) 16 14 Yes 2 GSPS 0.005 (OCXO option) 2/1 Embedded or True IQ data via 1 x USB 3.1 GEN 1. Internet remote via HTTP / JSON Yes Yes No 1 x XC7A200T-2 (930 GMACs)
References ^ "Why it is preferred to have local oscillator frequency larger than carrier frequency in superheterodyne receiver?". electronics.stackexchange.com. Retrieved 4 February 2019. Double tuned Superheterodyne receivers usually contain double tuned circuits (sets of two loosely coupled circuits) as filters in IF receiver - this is because such a filter has almost flat band instead a ...
A 5-tube superheterodyne receiver manufactured by Toshiba circa 1955 Superheterodyne transistor radio circuit circa 1975. A superheterodyne receiver, often shortened to superhet, is a type of radio receiver that uses frequency mixing to convert a received signal to a fixed intermediate frequency (IF) which can be more conveniently processed than the original carrier frequency.
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Pages for logged out editors learn more
A direct-conversion receiver (DCR), also known as a homodyne, synchrodyne, zero intermediate frequency or zero-IF receiver, is a radio receiver design that demodulates the incoming radio signal using synchronous detection driven by a local oscillator whose frequency is identical to, or very close to the carrier frequency of the intended signal.
It is a regenerative amplifier adjusted to provide positive feedback within the receiver. This has the effect of narrowing the receiver's bandwidth, as if the Q factor of its tuned circuits had been increased. The Q multiplier was a common accessory in shortwave receivers of the vacuum tube era as either a factory installation or an add-on ...