Search results
Results from the WOW.Com Content Network
PO gpm = pump output in gpm (gallons per minute) 1 gallon = 0.0238095238 barrels; ID 2 = inside diameter of the wellbore or casing, squared; OD 2 = outside diameter of the drill pipe or tubing, squared; 1029.4 = A conversion factor constant used to calculate the volume between the outside of a tube within the inside of another tube, using barrels.
The relationship between gallons per minute (gpm) and fixture unit is not constant, but varies with the number of fixture units. For example, 1000 FU is equivalent to 220 US gallons per minute (0.014 m 3 /s) while 2000 FU represents only 330 US gallons per minute (0.021 m 3 /s), about 1.5 times the flow rate.
The SI unit is cubic metres per second (m 3 /s). Another unit used is standard cubic centimetres per minute (SCCM). In US customary units and imperial units, volumetric flow rate is often expressed as cubic feet per second (ft 3 /s) or gallons per minute (either US or imperial definitions).
K-Factors have also previously been calculated and published using the United States customary units of pound per square inch (psi) and gallon per minute (gpm). Within the United States, US measurements are still often used instead of metric. [3] [4]
gallon (US fluid) per day GPD [citation needed] ≡ 1 gal/d = 4.381 263 63 8 × 10 −8 m 3 /s gallon (US fluid) per hour GPH [citation needed] ≡ 1 gal/h = 1.051 503 27 3 × 10 −6 m 3 /s gallon (US fluid) per minute GPM [citation needed] ≡ 1 gal/min = 6.309 019 64 × 10 −5 m 3 /s: litre per minute l/min or L/min ≡ 1 L/min = 1. 6 × 10 ...
With C v = 1.0 and 200 psia inlet pressure, the flow is 100 standard cubic feet per minute (scfm). The flow is proportional to the absolute inlet pressure, so the flow in scfm would equal the C v flow coefficient if the inlet pressure were reduced to 2 psia and the outlet were connected to a vacuum with less than 1 psi absolute pressure (1.0 ...
The equation for head loss in pipes, also referred to as slope, S, expressed in "feet per foot of length" vs. in 'psi per foot of length' as described above, with the inside pipe diameter, d, being entered in feet vs. inches, and the flow rate, Q, being entered in cubic feet per second, cfs, vs. gallons per minute, gpm, appears very similar.
where: [2] Q f = total residual flow during the test (gallons per minute); c = discharge coefficient (unitless). This is usually 1.0 if using a diffuser. If using a wand to measure the stagnation pressure, the coefficient value depends on the shape of the flow hydrant orifice.