Search results
Results from the WOW.Com Content Network
1⁄27 yd 3. SI units. 0.02831685 m 3. The cubic foot (symbol ft3 or cu ft) [1] is an imperial and US customary (non-metric) unit of volume, used in the United States and the United Kingdom. It is defined as the volume of a cube with sides of one foot (0.3048 m) in length. Its volume is 28.3168 L (about 1⁄35 of a cubic metre).
For petroleum gases, the standard cubic foot (scf) is defined as one cubic foot of gas at 60 °F (288.7 K; 15.56 °C) and at normal sea level air pressure. The pressure definition differs between sources, but are all close to normal sea level air pressure. A pressure of 14.696 pounds per square inch (1.00000 atm; 101.325 kPa). [2]
statvolt (CGS unit) statV. ≘ c ⋅ (1 μJ/A⋅m) = 299.792458V. volt (SI unit) V. The difference in electric potential across two points along a conducting wire carrying one ampere of constant current when the power dissipated between the points equals one watt. [ 32 ] = 1 V = 1 W/A = 1 kg⋅m2/ (A⋅s3) = 1 J/C.
US customary. 1⁄231 US Gallon. nonstandard. 1⁄1728 ft 3. The cubic inch (symbol in3) is a unit of volume in the Imperial units and United States customary units systems. It is the volume of a cube with each of its three dimensions (length, width, and height) being one inch long which is equivalent to 1/231 of a US gallon. [1]
gc (engineering) g. c. (engineering) In engineering and physics, gc is a unit conversion factor used to convert mass to force or vice versa. [1] It is defined as. In unit systems where force is a derived unit, like in SI units, gc is equal to 1. In unit systems where force is a primary unit, like in imperial and US customary measurement systems ...
v. t. e. In physics and engineering, in particular fluid dynamics, the volumetric flow rate (also known as volume flow rate, or volume velocity) is the volume of fluid which passes per unit time; usually it is represented by the symbol Q (sometimes ). It contrasts with mass flow rate, which is the other main type of fluid flow rate.
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property ...
An input unit can be converted to any number of output units—the outputs are specified as a "combination" by separating unit codes with a space (" ") or a plus (" + "). Using a space as a separator does not work if any of the unit codes contains a space. For example, each of the following converts 1.2 km 2 to acres, square yards, and hectares.