Ad
related to: serial device analyzer
Search results
Results from the WOW.Com Content Network
A serial line analyzer is a device similar to a logic analyzer but specialized for RS-232's voltage levels, connectors, and, where used, clock signals; it collects, stores, and displays the data and control signals, allowing developers to view them in detail.
A typical bus analyzer: this one has an adaptor pod to allow it to interface to Serial ATA devices. A bus analyzer is a type of a protocol analysis tool, used for capturing and analyzing communication data across a specific interface bus, usually embedded in a hardware system. The bus analyzer functionality helps design, test and validation ...
On devices like modems, bytes may be more than 8 bits long because they may be individually padded out with additional start and stop bits; the figures below will reflect this. Where channels use line codes (such as Ethernet , Serial ATA , and PCI Express ), quoted rates are for the decoded signal.
Management Data Input/Output (MDIO), also known as Serial Management Interface (SMI) or Media Independent Interface Management (MIIM), is a serial bus defined for the Ethernet family of IEEE 802.3 standards for the Media Independent Interface, or MII. The MII connects media access control (MAC) devices with Ethernet physical layer (PHY ...
Using a Bus Pirate, a developer can use a serial terminal to interface with a device, via such hardware protocols as SPI, I 2 C and 1-Wire. The Bus Pirate is capable of programming low-end microcontrollers, such as Atmel AVRs and Microchip PICs. Programming using more advanced protocols such as JTAG and SWD is possible, but is discouraged due ...
Many serial communication systems were originally designed to transfer data over relatively large distances through some sort of data cable.. Practically all long-distance communication transmits data one bit at a time, rather than in parallel, because it reduces the cost of the cable.
Each device internally uses a shift register for serial communication, which together forms an inter-chip circular buffer. Sub devices should use tri-state outputs so their MISO signal becomes high impedance (electrically disconnected) when the device is not selected. Subs without tri-state outputs cannot share a MISO line with other subs ...
The individual signals on a serial port are unidirectional and when connecting two devices, the outputs of one device must be connected to the inputs of the other. Devices are divided into two categories: data terminal equipment (DTE) and data circuit-terminating equipment (DCE). A line that is an output on a DTE device is an input on a DCE ...
Ad
related to: serial device analyzer