Search results
Results from the WOW.Com Content Network
Using this term, one can calculate many things in the same way as for a round tube. When the cross-section is uniform along the tube or channel length, it is defined as [1] [2] =, where A is the cross-sectional area of the flow, P is the wetted perimeter of the cross-section.
A swimming pool, swimming bath, wading pool, paddling pool, or simply pool, is a structure designed to hold water to enable swimming or other leisure activities. Pools can be built into the ground (in-ground pools) or built above ground (as a freestanding construction or as part of a building or other larger structure), and may be found as a ...
Precipitators use a rapping system to release the dirt. The crumbling dust falls into the hopper. Once the material in the hopper reaches capacity, it is released through an opening in the bottom with a diameter of about 8–12 inches (20–30 cm). Hoppers are rectangular or circular in cross section but have sides that slope at about a 60° angle.
Assembled tremie placing concrete underwater Hopper, pipes and lifting cap components of a tremie concrete placement tube. A tremie is a watertight pipe, usually of about 250 mm inside diameter (150 to 300 mm), [1] with a conical hopper at its upper end above the water level. It may have a loose plug or a valve at the bottom end.
Hydraulic jump in a rectangular channel, also known as classical jump, is a natural phenomenon that occurs whenever flow changes from supercritical to subcritical flow. In this transition, the water surface rises abruptly, surface rollers are formed, intense mixing occurs, air is entrained, and often a large amount of energy is dissipated.
A percentage is typically added to neat volume to estimate loose (i.e. uncompacted) volumes for procurement purposes. With concrete work, neat volume is calculated assuming there is no bowing in the formwork , or, for cast-in-place concrete, that the surfaces in contact with the concrete have no voids or imperfections that would require a ...
A typical concrete mixer uses a revolving drum to mix the components. For smaller volume works, portable concrete mixers are often used so that the concrete can be made at the construction site, giving the workers ample time to use the concrete before it hardens. An alternative to a machine is mixing concrete by hand.
The weight of the element can be determined by the calculated volume, and using the specific gravity (normal weight reinforced concrete is approximately 24 kN/m3). Establishing the lifting anchor positions will influence the rigging arrangements used and therefore the static analysis of the rigging should be determined.