Search results
Results from the WOW.Com Content Network
Sometimes tilt sensors are incorrectly called inclinometers because the sensors simply generate a signal (as opposed to inclinometers that generate a reading and a signal). A basic circuit using a tilt sensor is shown here. For this assembly, the components used are: a tilt sensor, a 470 Ohms resistor, a LED and a 3V power supply.
These are dependent on the behavior of the measuring sensor, the final control element (such as a control valve), any control signal delays, and the process itself. Approximate values of constants can usually be initially entered knowing the type of application, but they are normally refined, or tuned, by introducing a setpoint change and ...
An inclinometer sensor's true or absolute accuracy (which is the combined total error), however, is a combination of initial sets of sensor zero offset and sensitivity, sensor linearity, hysteresis, repeatability, and the temperature drifts of zero and sensitivity—electronic inclinometers accuracy can typically range from ±0.01–2 ...
The open-circuit time constant (OCT) method is an approximate analysis technique used in electronic circuit design to determine the corner frequency of complex circuits.It is a special case of zero-value time constant (ZVT) method technique when reactive elements consist of only capacitors.
This was a simple arrangement of two water pots, connected by a long water-filled tube. Any change in tilt would be registered by a difference in fill-mark of one pot compared to the other. Although extensively used throughout the world for Earth-science research, they have proven to be quite difficult to operate.
There are several different basic designs (tilt, displacement, radial, etc.) but they all share the common design strength of non-eroding switch contacts. The most common is the mercury tilt switch. It is in one state (open or closed) when tilted one direction with respect to horizontal, and the other state when tilted the other direction.
Tilt test on a fitting discontinuity. In geomechanics, a tilt test is a simple test to estimate the shear strength parameters of a discontinuity. [1] [2] Two pieces of rock containing a discontinuity are held in hand or mounted in test equipment with the discontinuity horizontal. The sample is slowly tilted until the top block moves.
Symbolic circuit analysis is a formal technique of circuit analysis to calculate the behaviour or characteristic of an electric/electronic circuit with the independent variables (time or frequency), the dependent variables (voltages and currents), and (some or all of) the circuit elements represented by symbols. [1] [2]