Search results
Results from the WOW.Com Content Network
This regulation defines a standard cubic foot, for compressed or liquefied gases in refillable cylinders other than LPG by, "A standard cubic foot of gas is defined as a cubic foot at a temperature of 21 °C (70 °F) and a pressure of 101.325 kilopascals [kPa] (14.696 psia)". [4]
Actual cubic foot per minute (ACFM) is the volume of gas flowing anywhere in a system, taking into account its temperature and pressure. If the system were moving a gas at exactly the "standard" condition, then ACFM would equal SCFM.
A standard cubic foot (abbreviated scf) is a measure of quantity of gas, sometimes [clarification needed] defined in terms of standard temperature and pressure as a cubic foot of volume at 60 °F (16 °C; 289 K) and 14.7 pounds per square inch (1.01 bar; 101 kPa) of pressure. [citation needed]
At standard mean sea level it specifies a temperature of 15 °C (59 °F), pressure of 101,325 pascals (14.6959 psi) (1 atm), and a density of 1.2250 kilograms per cubic meter (0.07647 lb/cu ft). It also specifies a temperature lapse rate of −6.5 °C (−11.7 °F) per km (approximately −2 °C (−3.6 °F) per 1,000 ft).
Standard cubic feet per minute (SCFM) is a volumetric flow-rate corrected to a set of "standardized" conditions of pressure, temperature, and relative humidity. The standard conditions are often defined as 14.7 psia, temperature 70°F and relative humidity 0%, but the conditions may vary depending on the "standard" used.
A standard cubic foot (scf) is the USA expression of gas volume at standard conditions and it is often (but not always) defined as being measured at 60 °F and 1 atmosphere of pressure. There are other definitions of standard gas conditions used in the USA besides 60 °F and 1 atmosphere. That being understood:
The standard temperature for metric measurement is 15 degrees Celsius (i.e. 59 degrees Fahrenheit) while for English measurement the standard temperature is 60 °F. Gas undergoes a slight expansion when the temperature is raised from 15 °C (59 °F) to 60 °F and this expansion is built into the above factor for gas.
A related measure is "mega standard cubic metres per day" (MSm 3 /d), which is equal to 10 6 Sm 3 /d used in many countries outside the United States. [1] One MMSCFD equals 1177.6 Sm 3 /h. When converting to mass flowrate, the density of the gas should be used at Standard temperature and pressure.