Search results
Results from the WOW.Com Content Network
The parts included in the typical US mortise lock installation are the lock body (the part installed inside the mortise cut-out in the door); the lock trim (which may be selected from any number of designs of doorknobs, levers, handle sets and pulls); a strike plate (or box keep), which lines and reinforces the cavity in the door jamb or frame ...
Door with two locks, one in the doorknob and a separate deadbolt. A deadbolt or deadlock is a type of lock morticed into a wooden door where a bolt is thrown into the door frame, using a key from either side, to secure the door. [1] It is distinct from a spring bolt lock because a deadbolt can only be opened by a key or handle.
Installing a single receptacle is often cheaper or more convenient than providing this GFCI protection at the circuit breaker. In addition, a tripped GFCI receptacle may be more easily noticed and reset, as compared to a tripped GFCI located in a remote circuit breaker panel far from the point of usage.
The jambs of a window outside the frame are called reveals. Small shafts to doors and windows with caps and bases are called jamb-shafts; when in the inside arris of the jamb of a window, they are sometimes called scoinsons. [2] A doorjamb, door jamb, or sometimes doorpost is the vertical portion of the door frame onto which a door is secured. [3]
Common 3 phase configurations within a building are 208v/120 wye, 120/240 center tapped delta and 480v/277v wye. Lighting is usually fed by 277 V or 120v. Countries such as Mexico may adopt the NFPA standard as their national electrical code, with local amendments similar to those in United States jurisdictions.
The Grand Cherokee's origins date back to 1983, when American Motors Corporation (AMC) was designing a successor to the Jeep Cherokee. [3] Three outside (non-AMC) designers—Larry Shinoda, Alain Clenet, and Giorgetto Giugiaro—were also under contract with AMC to create and build a clay model of the Cherokee XJ replacement, then known as the "XJC" project. [4]
The U.S. National Electrical Code (NEC) defines a switchboard as "a large single panel, frame, or assembly of panels on which are mounted, on the face, back, or both, switches, over-current and other protective devices, buses, and usually instruments". [2]
An industrial electric motor . An electric motor is a machine that converts electrical energy into mechanical energy.Most electric motors operate through the interaction between the motor's magnetic field and electric current in a wire winding to generate force in the form of torque applied on the motor's shaft.