enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Self-clocking signal - Wikipedia

    en.wikipedia.org/wiki/Self-clocking_signal

    Asynchronous self-clocking signals do not combine clock cycles and data transfer into one continuous signal. Instead, the transmission of clock cycles and data transmission is modulated. Below is an example signal used in asynchronous serial communication, where it is made clear that the information about the clock speed is transmitted in a ...

  3. Clock signal - Wikipedia

    en.wikipedia.org/wiki/Clock_signal

    Clock signal and legend. In electronics and especially synchronous digital circuits, a clock signal (historically also known as logic beat) [1] is an electronic logic signal (voltage or current) which oscillates between a high and a low state at a constant frequency and is used like a metronome to synchronize actions of digital circuits.

  4. Data communication - Wikipedia

    en.wikipedia.org/wiki/Data_communication

    Data transmitted may be digital messages originating from a data source, for example a computer or a keyboard. It may also be an analog signal such as a phone call or a video signal, digitized into a bit-stream for example using pulse-code modulation (PCM) or more advanced source coding (analog-to-digital conversion and data compression) schemes.

  5. Source-synchronous - Wikipedia

    en.wikipedia.org/wiki/Source-synchronous

    The former is eliminated since both clock and data signals are driven by identical flip-flops on the same silicon at the same temperature and voltage, thereby equalizing the seen by both clock and data. The latter is eliminated for the same reason - since the clock and data are driven by identical devices and (ideally) connected with wires of ...

  6. Manchester code - Wikipedia

    en.wikipedia.org/wiki/Manchester_code

    Manchester coding is a special case of binary phase-shift keying (BPSK), where the data controls the phase of a square wave carrier whose frequency is the data rate. . Manchester code ensures frequent line voltage transitions, directly proportional to the clock rate; this helps clock

  7. Comparison of synchronous and asynchronous signalling

    en.wikipedia.org/wiki/Comparison_of_synchronous...

    A pulse on one signal indicates when another bit of information is ready on the other signal. The asynchronous signalling methods use only one signal. The receiver uses transitions on that signal to figure out the transmitter bit rate (" autobaud ") and timing, and set a local clock to the proper timing, typically using a phase-locked loop (PLL ...

  8. Clock recovery - Wikipedia

    en.wikipedia.org/wiki/Clock_recovery

    Clock recovery addresses this problem by embedding clock information into the data stream, allowing the transmitter's clock timing to be determined. This normally takes the form of short signals inserted into the data that can be easily seen and then used in a phase-locked loop or similar adjustable oscillator to produce a local clock signal ...

  9. Digital timing diagram - Wikipedia

    en.wikipedia.org/wiki/Digital_timing_diagram

    A digital timing diagram represents a set of signals in the time domain. [1] A timing diagram can contain many rows, usually one of them being the clock. It is a tool commonly used in digital electronics, hardware debugging, and digital communications.