enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. 2.5GBASE-T and 5GBASE-T - Wikipedia

   en.wikipedia.org/wiki/2.5GBASE-T_and_5GBASE-T

   By bonding the connections from multiple Ethernet ports via IEEE 802.3ad link aggregation or similar, manufacturers were able to achieve speeds close to 2 Gbit/s by using two ports that support gigabit speeds. This would require the wireless access point to be connected to the rest of the network with 2 Ethernet cables and require both the ...

3. List of interface bit rates - Wikipedia

   en.wikipedia.org/wiki/List_of_interface_bit_rates

   DOCSIS 2.0 [13] (cable modem) 38/27 Mbit/s: ... 10/2.5 Gbit/s: 1.25/0.3125 ... AoE over gigabit Ethernet, jumbo frames [s] 1 Gbit/s:

4. Category 5 cable - Wikipedia

   en.wikipedia.org/wiki/Category_5_cable

   The cable standard prescribes performance parameters for frequencies up to 100 MHz and is suitable for 10BASE-T, 100BASE-TX (Fast Ethernet), 1000BASE-T (Gigabit Ethernet), and 2.5GBASE-T. 10BASE-T and 100BASE-TX Ethernet connections require two wire pairs. 1000BASE-T and faster Ethernet connections require four wire pairs.

5. Gigabit Ethernet - Wikipedia

   en.wikipedia.org/wiki/Gigabit_Ethernet

   Supermicro AOC-SGP-I2 dual-port Gigabit Ethernet NIC, a PCI Express ×4 card. 1000BASE-T (also known as IEEE 802.3ab) is a standard for Gigabit Ethernet over twisted-pair wiring. Each 1000BASE-T network segment is recommended to be a maximum length of 100 meters (330 feet), [5] [a] and must use Category 5 cable or better (including Cat 5e and ...

6. Ethernet over twisted pair - Wikipedia

   en.wikipedia.org/wiki/Ethernet_over_twisted_pair

   Most Ethernet cables are wired straight-through (pin 1 to pin 1, pin 2 to pin 2, and so on). In some instances, the crossover form (receive to transmit and transmit to receive) may still be required. Cables for Ethernet may be wired to either the T568A or T568B termination standards at both ends of the cable. Since these standards differ only ...

7. Ethernet physical layer - Wikipedia

   en.wikipedia.org/wiki/Ethernet_physical_layer

   The first generation of 100 Gigabit Ethernet using 10 and 25 Gbit/s lanes was standardized in June 2010 as IEEE 802.3ba alongside 40 Gigabit Ethernet. [21] The second generation using 50 Gbit/s lanes was developed by the IEEE 802.3cd task force along with 50 and 200 Gbit/s standards. [24]