enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Trailing-arm suspension - Wikipedia

   en.wikipedia.org/wiki/Trailing-arm_suspension

   These are typically used on the rear axle or wheels of vehicles, but also found in both front and main landing gear of aircraft. A "semi trailing-arm" (or semi trailing-link) is a common form of independent rear suspension on automobiles, particularly those with front wheel drive (where it allows a flatter rear floor pan).

3. Transverse leaf spring front suspension - Wikipedia

   en.wikipedia.org/wiki/Transverse_leaf_spring...

   The axle receives its vertical and transverse support from a transverse leaf spring (leaf springs were often used for support in more than one direction), and its longitudinal support from fore-aft links sometimes called "radius rods" which are attached (via pivots) to the ends of the axle at their forward end and to the sides of the chassis ...

4. Car suspension - Wikipedia

   en.wikipedia.org/wiki/Car_suspension

   A dependent suspension normally has a beam (a simple 'cart' axle) or a (driven) live axle that holds wheels parallel to each other and perpendicular to the axle. When the camber of one wheel changes, the camber of the opposite wheel changes in the same way (by convention, on one side, this is a positive change in the camber, and on the other ...

5. Fork end - Wikipedia

   en.wikipedia.org/wiki/Fork_end

   A fork end, [1] fork-end, [1] or forkend [2] is a slot in a bicycle frame or bicycle fork where the axle of a bicycle wheel is attached. A dropout is a type of fork end [3] that allows the rear wheel to be removed without first derailing the chain. Track bicycle frames have track fork ends, on which the opening faces rearwards. Because they do ...

6. Twist-beam rear suspension - Wikipedia

   en.wikipedia.org/wiki/Twist-beam_rear_suspension

   The twist-beam rear suspension (also torsion-beam axle, deformable torsion beam, or compound crank) is a type of automobile suspension based on a large H- or C-shaped member. The front of the H attaches to the body via rubber bushings , and the rear of the H carries each stub-axle assembly, on each side of the car.

7. Bicycle fork - Wikipedia

   en.wikipedia.org/wiki/Bicycle_fork

   The length of the fork is usually measured parallel to the steerer tube from the bottom of the lower bearing race to the center of the front wheel axle. [3] A 1996 survey of 13 700c road forks found a maximum length of 374.7 mm and a minimum of 363.5 mm. [citation needed]

8. The 6 Best Canned Soups for Better Blood Sugar ... - AOL

   www.aol.com/6-best-canned-soups-better-110000023...

   Where to shop today's best deals: Kate Spade, Amazon, Walmart and more

9. Jaguar independent rear suspension - Wikipedia

   en.wikipedia.org/wiki/Jaguar_independent_rear...

   It is sitting far higher than it would mounted in the car, as it is not sprung with the car's rear mass. The side struts sit about horizontally in the live installation. Jaguar's independent rear suspension (IRS) unit has been a common component of a number of Jaguar production cars since 1961, passing through two major changes of configuration ...