Search results
Results from the WOW.Com Content Network
Other ceramic pieces would typically be used as a junction point between the wiring system proper, and the more flexible cloth-clad wiring found in light fixtures or other permanent, hard-wired devices. When a generic power outlet was desired, the wiring could run directly into the junction box through a tube of protective loom and a ceramic ...
A small metal, plastic or fiberglass junction box may form part of an electrical conduit or thermoplastic-sheathed cable (TPS) wiring system in a building. If designed for surface mounting, it is used mostly in ceilings, concrete or concealed behind an access panel—particularly in domestic or commercial buildings. [2]
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
In light-frame construction, a trimmer is a timber or metal beam (joist) used to create an opening around a stairwell, skylight, chimney, and the like. Trimmers are installed parallel to the primary floor or ceiling joists and support headers , which run perpendicular to the primary joists.
Cove lighting is a form of indirect lighting built into ledges, recesses, or valances in a ceiling or high on the walls of a room. It directs light up towards the ceiling and down adjacent walls. [1] It may be used as primary lighting, or for aesthetic accent, especially to highlight decorative ceilings.
A distribution board (also known as panelboard, circuit breaker panel, breaker panel, electric panel, fuse box or DB box) is a component of an electricity supply system that divides an electrical power feed into subsidiary circuits while providing a protective fuse or circuit breaker for each circuit in a common enclosure.
A right-hand railroad switch with point indicator pointing to right Animated diagram of a right-hand railroad switch. Rail track A divides into two: track B (the straight track) and track C (the diverging track); note that the green line represents direction of travel only, the black lines represent fixed portions of track, and the red lines depict the moving components.
trimmer or jack − stud to the left or right of a window or door that runs from the bottom plate to the underside of a lintel or header; cripple stud – a stud located either above or below a framed opening, that does not run the full height of the wall; post or column − a doubled or other integral multiple of a group of studs nailed side ...