Search results
Results from the WOW.Com Content Network
SparkFun ESP8266 Thing. The reason for the popularity of many of these boards over the earlier ESP-xx modules is the inclusion of an on-board USB-to-UART bridge (like the Silicon Labs' CP2102 or the WCH CH340G) and a Micro-USB connector, coupled with a 3.3-volt regulator to provide both power to the board and connectivity to the host (software development) computer – commonly referred to as ...
NavSpark has 17 GPIO pins, which include two UARTs, 1 I²C, 1 SPI, 1 PWM, and a trigger. The first UART is usually used by the GNSS software to output NMEA 0183 data, although this can be disabled. This UART communicates over USB through a PL2303 serial converter and the transmit output is also made available on a pin.
NavSpark has 17 GPIO pins, which include two UARTs, 1 I 2 C, 1 SPI, 1 PWM, and a trigger. The first UART is usually used by the GNSS software to output NMEA 0183 data, although this can be disabled. This UART communicates over USB through a PL2303 serial converter and the transmit output is also made available on a pin.
NodeMCU was created shortly after the ESP8266 came out. On December 30, 2013, Espressif Systems [6] began production of the ESP8266. [12] NodeMCU started on 13 Oct 2014, when Hong committed the first file of nodemcu-firmware to GitHub. [13]
It runs on ESP8266 [2] Wi-Fi based MCU (microcontroller unit) platforms for IoT from Espressif Systems. The name "ESP Easy," by default, refers to the firmware rather than the hardware on which it runs. [3] [4] At a low level, the ESP Easy firmware works the same as the NodeMCU firmware and also provides a very simple operating system on the ...
A GPIO port is a group of GPIO pins (often 8 pins, but it may be less) arranged in a group and controlled as a group. GPIO abilities may include: [2] GPIO pins can be configured to be input or output; GPIO pins can be enabled/disabled; Input values are readable (usually high or low) Output values are writable/readable
The Arduino Uno is an open-source microcontroller board based on the Microchip ATmega328P microcontroller (MCU) and developed by Arduino.cc and initially released in 2010. [2] [3] The microcontroller board is equipped with sets of digital and analog input/output (I/O) pins that may be interfaced to various expansion boards (shields) and other circuits. [1]
ATtiny2313 in 20-pin narrow dual in-line package (DIP-20N)ATtiny (also known as TinyAVR) is a subfamily of the popular 8-bit AVR microcontrollers, which typically has fewer features, fewer I/O pins, and less memory than other AVR series chips.