Search results
Results from the WOW.Com Content Network
Regenerative receivers require fewer components than other types of receiver circuit, such as the TRF and superheterodyne. The circuit's advantage was that it got much more amplification (gain) out of the expensive vacuum tubes , thus reducing the number of tubes required and therefore the cost of a receiver.
The regenerative receiver also had its heyday at the time where adding an active element (vacuum tube) was considered costly. In order to increase the gain of the receiver, positive feedback was used in its single RF amplifier stage; this also increased the selectivity of the receiver well beyond what would be expected from a single tuned circuit.
The receiver sensitivity rises while the oscillation builds up. The oscillation stops when the operation point no longer fulfills the Barkhausen stability criterion. The blocking oscillator recovers to the initial state and the cycle starts again. [2] The receive frequency of the Armstrong Super-Regenerative receiver was some hundred kilohertz.
References ^ "Why it is preferred to have local oscillator frequency larger than carrier frequency in superheterodyne receiver?". electronics.stackexchange.com. Retrieved 4 February 2019. Double tuned Superheterodyne receivers usually contain double tuned circuits (sets of two loosely coupled circuits) as filters in IF receiver - this is because such a filter has almost flat band instead a ...
This page was last edited on 20 October 2005, at 01:17 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike License 4.0; additional terms may apply.
C1 is the gridleak capacitor. C2 is a radio frequency bypass capacitor. L4 is an inductance without inductive coupling to L. Together with the tube internal capacitor between anode and grid L4 creates a negative differential resistance at the grid. Regenerative control is as in Fig. 8. Fig. 10 AM band NPN audion receiver
Hours after the St. Petersburg City Council approved spending $23.7 million to repair Tropicana Field after it was damaged during Hurricane Milton, the council reversed its decision in a second vote.
A direct-conversion receiver (DCR), also known as homodyne, synchrodyne, or zero-IF receiver, is a radio receiver design that demodulates the incoming radio signal using synchronous detection driven by a local oscillator whose frequency is identical to, or very close to the carrier frequency of the intended signal.