enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Balun - Wikipedia

   en.wikipedia.org/wiki/Balun

   Isolation transformer. In classical transformers, there are two electrically separate windings of wire coils around the transformer's core. The advantage of transformer-type over other types of balun is that the electrically separate windings for input and output allow these baluns to connect circuits whose ground-level voltages are subject to ground loops or are otherwise electrically ...

3. AOL Mail

   mail.aol.com

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

4. Subwoofer - Wikipedia

   en.wikipedia.org/wiki/Subwoofer

   Manifold subwoofers have two or more subwoofer speakers that feed the throat of a single horn. This increases SPL for the subwoofer, at the cost of increased distortion. EV has a manifold speaker cabinet in which four drivers are mounted as close together as practical. This is a different design than the "multiple drivers in one throat" approach.

5. D-subminiature - Wikipedia

   en.wikipedia.org/wiki/D-subminiature

   A D-sub contains two or more parallel rows of pins or sockets usually surrounded by a D-shaped metal shield, or shell, that provides mechanical support, ensures correct orientation, and may screen against electromagnetic interference. Calling that shield a shell (or D-shell) can be ambiguous, as the term shell is also short for the cable shell ...

6. Electrical conductor - Wikipedia

   en.wikipedia.org/wiki/Electrical_conductor

   where is the length of the conductor, measured in metres [m], A is the cross-section area of the conductor measured in square metres [m 2], σ is the electrical conductivity measured in siemens per meter (S·m −1), and ρ is the electrical resistivity (also called specific electrical resistance) of the material, measured in ohm-metres (Ω·m ...

7. Impedance matching - Wikipedia

   en.wikipedia.org/wiki/Impedance_matching

   [2] A simple electrical impedance-matching network requires one capacitor and one inductor. In the figure to the right, R 1 > R 2, however, either R 1 or R 2 may be the source and the other the load. One of X 1 or X 2 must be an inductor and the other must be a capacitor. One reactance is in parallel with the source (or load), and the other is ...