enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   Fractional drill bit set by Craftsman. Fractional-inch drill bit sizes are still in common use in the United States and in any factory (around the globe) that makes inch-sized products for the U.S. market. ANSI B94.11M-1979 sets size standards for jobber-length straight-shank twist drill bits from 1/64 inch through 1 inch in 1/64 inch increments.

3. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, fine): For 7 ⁄ 16-20 (same diameter as the previous example, but this time with 20 threads per inch, which is considered fine), 0.437 in × 0.90 = 0.393 in (i.e., if the threads are to be fine, then a slightly larger diameter drill bit should be used before tapping the hole for the screw).

4. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   A bit used to enlarge an existing hole is called a core drill bit. The existing hole may be the result of a core from a casting or a stamped (punched) hole. The name comes from its first use, for drilling out the hole left by a foundry core, a cylinder placed in a mould for a casting that leaves an irregular hole in the product. This core drill ...

5. Annular cutter - Wikipedia

   en.wikipedia.org/wiki/Annular_cutter

   An annular cutter (also called a core drill, core cutter, broach cutter, trepanning drill, hole saw, or cup-type cutter) is a form of core drill used to create holes in metal. An annular cutter, named after the annulus shape , cuts only a groove at the periphery of the hole and leaves a solid core or slug at the center.

6. Robertson screw - Wikipedia

   en.wikipedia.org/wiki/Robertson_screw

   Screwdriver bits in different sizes for Robertson screws. When Henry Ford tried the Robertson screws, he found that they saved considerable time in Model T production. When Robertson refused to license the design, Ford realized that the supply of screws would not be guaranteed, and chose to limit their use to his Canadian division. [4] [5] [6]

7. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   A center punch is used to mark the center of a point. It is usually used to mark the center of a hole when drilling holes. A drill has the tendency to "wander" if it does not start in a recess. A center punch forms a large enough dimple to "guide" the tip of the drill. The tip of a center punch has an angle between 60 and 90 degrees. [1]