Search results
Results from the WOW.Com Content Network
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Pages for logged out editors learn more
Spackling paste or spackle is a putty used to fill holes, small cracks, and other minor surface defects in wood, drywall, and plaster. [ 1 ] [ 2 ] Typically, spackling is composed of gypsum plaster from hydrated calcium sulfate and glue .
Kitchen renovation spackling to cover holes and tape between sheetrock boards Drywall with joint compound applied.. Joint compound (also known as drywall compound, drywall mud, joint cement or mastic) is a white powder of primarily gypsum dust mixed with water to form a paste the consistency of cake frosting, which is spread onto drywall and sanded when dry to create a seamless base for paint ...
Lift slab construction (also called the Youtz-Slick Method) is a method of constructing concrete buildings by casting the floor or roof slab on top of the previous slab and then raising (jacking) the slab up with hydraulic jacks. This method of construction allows for a large portion of the work to be completed at ground level, negating the ...
The ECC patch was used as a replacement to the previously existent expansion joint that linked two deck slabs. Expansion joints, commonly used in bridges to allow for the seasonal expansion and contraction of the concrete decks, are an example of a ubiquitous construction practice that could eventually be eliminated through the use of bendable ...
A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel- reinforced slabs, typically between 100 and 500 mm thick, are most often used to construct floors and ceilings, while thinner mud slabs may be used for exterior paving ( see below ).
Slabs are one of the greatest consumers of concrete in many buildings, [14] so reducing the slab mass can make a relatively large difference to the environmental impact of a building's construction. Biaxial slabs may be marginally cheaper than solid slabs, partly due to the lower mass.
3D concrete printing with binder jetting technologies has been demonstrated at large scale by Enrico Dini with D-Shape. [13] D-Shape relies on a non-hydraulic Sorel cement that is based on sand activated with magnesium oxide in the powder bed and a liquid magnesium chloride solution as binder. The technology has mainly been used to create ...