Search results
Results from the WOW.Com Content Network
The losses due to input impedance (loss) in these circuits will be minimized, and the voltage at the input of the amplifier will be close to voltage as if the amplifier circuit was not connected. When a device whose input impedance could cause significant degradation of the signal is used, often a device with a high input impedance and a low ...
Typical instrumentation amplifier schematic. An instrumentation amplifier (sometimes shorthanded as in-amp or InAmp) is a type of differential amplifier that has been outfitted with input buffer amplifiers, which eliminate the need for input impedance matching and thus make the amplifier particularly suitable for use in measurement and test equipment.
Transimpedance amplifier with a reverse-biased photodiode. In the circuit shown in figure 1 the photodiode (shown as a current source) is connected between ground and the inverting input of the op-amp. The other input of the op-amp is also connected to ground. This provides a low-impedance load for the photodiode, which keeps the photodiode ...
The use of voltage gain figure is appropriate when the amplifier's input impedance is much higher than the source impedance, and the load impedance higher than the amplifier's output impedance. If two equivalent amplifiers are being compared, the amplifier with higher gain settings would be more sensitive as it would take less input signal to ...
Although the term Miller effect normally refers to capacitance, any impedance connected between the input and another node exhibiting gain can modify the amplifier input impedance via this effect. These properties of the Miller effect are generalized in the Miller theorem .
Only the magnitude of the loudspeaker impedance is used, and the power amplifier output impedance is assumed to be totally resistive. Comparison of damping factors for a solid state amplifier (Luxman L-509u) and a tube amplifier (Rogue Atlas) In typical solid state and tube amplifiers, the damping factor varies as a function of frequency.
Z-parameters are also known as open-circuit impedance parameters as they are calculated under open circuit conditions. i.e., I x =0, where x=1,2 refer to input and output currents flowing through the ports (of a two-port network in this case) respectively.
The op-amp inverting amplifier is a typical circuit, with parallel negative feedback, based on the Miller theorem, where the op-amp differential input impedance is apparently decreased to zero Zeroed impedance uses an inverting (usually op-amp) amplifier with enormously high gain A v → ∞ {\displaystyle A_{v}\to \infty } .