Search results
Results from the WOW.Com Content Network
[3] [4] [5] More specifically, it refers to the mechanism or lock of such firearms. It may also refer to a gun's lock which uses slow match to ignite the powder charge. [6] [7] The matchlock was a lever mechanism that simplified the ergonomics of firing. Slow match would be held clear of the flash pan in a spring-loaded pivoting arm (the ...
Again, the term refers to the lock mechanism, so a lock can be both a mortise lock and a lever tumbler lock. In the modern lever tumbler lock, the key moves a series of levers that allow the bolt to move in the door. [5] Pin tumbler lock, commonly used for mortise locks in the US. The next major innovation to mortise lock mechanisms came in 1865.
The pick is then used to lift each lever inside the lock to the correct height so that the locking bolt can pass. Higher security lever locks (such as the five-lever) usually have notches cut into the levers. These catch the locking bolt and prevent it from moving if picking is attempted (similar to the security pins in a pin tumbler lock).
Husqvarna Model 40, a Swedish copy of the Lahti, with holster and spare magazine. The Husqvarna Model 40 or m/40 [6] was manufactured 1940 to 1946 and was a Swedish copy of the Finnish Lahti pistol. [5] The Swedish army realized there would be a shortage of pistols in the event of large scale military mobilization in Europe. [6]
This 6-shot, .357 Magnum revolver uses a unique interchangeable barrel system, including a 2.5 in (64 mm) snub nose barrel along with 4 in (100 mm), 6 in (150 mm), 8 in (200 mm), 10 in (250 mm), 12 in (300 mm), and 15 in (380 mm), partial or fully-lugged shrouds with choices of solid or ventilated ribs, plus removable and interchangeable front ...
A Chubb detector lock is a lever tumbler lock with an integral security feature, a re-locking device, which frustrates unauthorised access attempts and indicates to the lock's owner that it has been interfered with. When someone tries to pick the lock or to open it using the wrong key, the lock is designed to jam in a locked state until ...
The Smith & Wesson Model 30 is a small-frame, six-shot, double-action revolver chambered for the .32 Long cartridge. It was based on the Smith & Wesson Hand Ejector Model of 1903, and could be had with either a blued or nickel finish. It was a "round butt" I-frame and was produced from 1948 to 1960 and was replaced by the J-frame Model 30–1 ...
Colt was the first manufacturer to produce a revolver with a swing-out cylinder. Smith & Wesson followed seven years later with the Hand Ejector, Model 1896 in .32 S&W Long caliber. This was an improvement over the Colt 1889 design since it used a combined center-pin and ejector rod to lock the cylinder in position.