Search results
Results from the WOW.Com Content Network
The M1879 Reichsrevolver, or Reichs-Commissions-Revolver Modell 1879 and 1883, were service revolvers used by the German Army from 1879 to 1908, when it was superseded by the Luger. [ 4 ] The two versions of the revolver differ in barrel length (The M1883 had a 5-inch barrel) and grip shape.
Revolving pistols held five shots and varied from "pocket" to "belt" and "holster" designations based upon size and intended mode of carry. Calibers ranged from .28 through .36 inches. The model most identified with the "Paterson Colt" designation is the Number 5 Holster or Texas Paterson (1,000 units), which was manufactured in .36 caliber.
Again, the term refers to the lock mechanism, so a lock can be both a mortise lock and a lever tumbler lock. In the modern lever tumbler lock, the key moves a series of levers that allow the bolt to move in the door. [5] Pin tumbler lock, commonly used for mortise locks in the US. The next major innovation to mortise lock mechanisms came in 1865.
Colt was the first manufacturer to produce a revolver with a swing-out cylinder. Smith & Wesson followed seven years later with the Hand Ejector, Model 1896 in .32 S&W Long caliber. This was an improvement over the Colt 1889 design since it used a combined center-pin and ejector rod to lock the cylinder in position.
The pick is then used to lift each lever inside the lock to the correct height so that the locking bolt can pass. Higher security lever locks (such as the five-lever) usually have notches cut into the levers. These catch the locking bolt and prevent it from moving if picking is attempted (similar to the security pins in a pin tumbler lock).
[3] [4] [5] More specifically, it refers to the mechanism or lock of such firearms. It may also refer to a gun's lock which uses slow match to ignite the powder charge. [6] [7] The matchlock was a lever mechanism that simplified the ergonomics of firing. Slow match would be held clear of the flash pan in a spring-loaded pivoting arm (the ...
Flatau envisioned mounting the item on a belt or a saddle. A modified hammer screw with a large head that protruded 3/4" from the frame would be installed on the Colt. This screw head would be inserted into the rig and held in place via a strip of spring steel that was attached to the gun belt via rivets.
Made by a large variety of Italian gun-makers, the Bodeo became the service revolver of the Italian Army in 1891. [2] The revolver was named after the head of the Italian commission that recommended its adoption, Carlo Bodeo. [3] It remained the principle handgun of the Italian Army until it was increasingly supplanted by the Glisenti Model ...