Search results
Results from the WOW.Com Content Network
[3] [4] [5] More specifically, it refers to the mechanism or lock of such firearms. It may also refer to a gun's lock which uses slow match to ignite the powder charge. [6] [7] The matchlock was a lever mechanism that simplified the ergonomics of firing. Slow match would be held clear of the flash pan in a spring-loaded pivoting arm (the ...
This system of drum rotation was developed in 1855 by E. K. Root, an employee of Samuel Colt (US Patent No. 13,999, Dec. 25, 1855, E.K. Root, Revolver) and applied to prototypes of the "Colt Root Revolver". From 1901 to 1924 the system was used in the Webley-Fosbery semi-automatic revolver manufactured by the Webley & Scott Company in Birmingham.
Unlike the Adams revolvers, which had dominated the British market since 1851, James Webley's revolvers mostly did not have a solid, one-piece frame and barrel, but instead had a two-piece body with an open frame, similar to the Colt 1851 Navy Revolver. In early Webley revolvers, the front part of the frame and the barrel formed a separate part ...
Two Colt Model 1851 Navy revolvers with same caliber and a Colt Root Model 1855 rifle, .36 cal. Colt Root carbines, .56 cal. The design of the Colt revolving rifle was essentially similar to revolver-type pistols, with a rotating cylinder that held five or six rounds in a variety of calibers from .36 to .64 inches. [1]
Again, the term refers to the lock mechanism, so a lock can be both a mortise lock and a lever tumbler lock. In the modern lever tumbler lock, the key moves a series of levers that allow the bolt to move in the door. [5] Pin tumbler lock, commonly used for mortise locks in the US. The next major innovation to mortise lock mechanisms came in 1865.
The M1879 Reichsrevolver, or Reichs-Commissions-Revolver Modell 1879 and 1883, were service revolvers used by the German Army from 1879 to 1908, when it was superseded by the Luger. [ 4 ] The two versions of the revolver differ in barrel length (The M1883 had a 5-inch barrel) and grip shape.
It was produced in a single item product with a 2-5/8" barrel. The Cloverleaf Model was more produced by far, and had two different variants, depending on the barrel length: 1-1/2" and 3". The 1-1/2" barrel length variant had an ejector rod contained within the center pin of the cylinder, allowing to reload while keeping the cylinder in the gun.
The author owns an example with a 5-inch barrel. Apparently, pockets were quite large in the fashions of the day. The Pocket Model went through an interesting evolution of features. Barrel length was typically between 3 + 1 ⁄ 2 and 5 + 1 ⁄ 2 inches long, though a few early specimens sported a 2 3/4 inch barrel. All have the frame top strap ...